Go Back   ChinaRiders Forums > Search Forums
Reload this Page Search Results
Register FAQ Community Calendar Today's Posts Search
Page 1 of 2 1 2
Showing results 1 to 25 of 35
Search took 0.01 seconds. Search: Posts Made By: RX3James
Forum: Zongshen RX3 11-19-2017, 11:49 PM
Replies: 16
Views: 5,116
Posted By RX3James
That is something I will definitely look at. I'll...

That is something I will definitely look at. I'll take off the fuel tank in the morning and see if there's a pinched or kinked line. However I haven't taken off the fuel tank in over 1000 miles so...
Forum: Zongshen RX3 11-19-2017, 02:54 PM
Replies: 16
Views: 5,116
Posted By RX3James
Ok sorry it took so long to get back to you all. ...

Ok sorry it took so long to get back to you all.

1st replaced the battery the other one was toast.
2nd replaced the spark plug the old one was very dirty.
3rd yes the fuel pump is spooling up...
Forum: Zongshen RX3 10-19-2017, 10:57 PM
Replies: 16
Views: 5,116
Posted By RX3James
RX3 won't start and I can't figure out why......

After the Bike sitting in the garage for a few months I pulled it out and tried to fire it up. Dead battery... so I put it on a trickle charge for a day and she fired right up. Took it out for trip...
Forum: Zongshen RX3 06-17-2016, 03:46 PM
Replies: 26
Views: 3,643
Posted By RX3James
I checked them the other day when I changed the...

I checked them the other day when I changed the oil and oiled the air filter. They were snug and looked clean. But...
Come to think of it I never had this issue until after I replaced the OEM...
Forum: Zongshen RX3 06-17-2016, 03:30 PM
Replies: 26
Views: 3,643
Posted By RX3James
This seems like a very reasonable answer. I'm not...

This seems like a very reasonable answer. I'm not a mechanic or welder so I can only go off what my inexperienced eyes see. That's why I posted here. This community has been extremely helpful getting...
Forum: Zongshen RX3 06-17-2016, 03:15 PM
Replies: 26
Views: 3,643
Posted By RX3James
As far as I know the skid plate has never been...

As far as I know the skid plate has never been impacted by anything. This bike has never even been off road. The bike is pretty buzzy so I do believe that vibration played a large part in the welds...
Forum: Zongshen RX3 06-17-2016, 03:05 PM
Replies: 26
Views: 3,643
Posted By RX3James
Battery died at around 200 miles( I bought a new...

Battery died at around 200 miles( I bought a new one with a two year warranty ), front rotor was warped causing pulsating front brakes (replaced under warranty ), had a chain issue causing it to...
Forum: Zongshen RX3 06-16-2016, 11:13 PM
Replies: 26
Views: 3,643
Posted By RX3James
Broken Skid plate welds......

I've just hit 2600 miles on my bike so I thought it do an oil change and switch to the 20w50 that was rumored to be the bees knees. Long story short.. I discovered my skid plate mounting bracket...
Forum: Zongshen RX3 05-10-2016, 10:50 PM
Replies: 71
Views: 12,628
Posted By RX3James
I've been reading a lot about the orientation of...

I've been reading a lot about the orientation of the OCS lately. So today I decided to take a look at mine. As you can see it's not in the correct position. Only one time did I ever notice any fluid...
Forum: Zongshen RX3 04-01-2016, 11:48 PM
Replies: 4
Views: 1,450
Posted By RX3James
Awesome day of riding!!

I took the RX3 out this morning on a ride with some of my friends. It was truly awesome. I only put about 70 miles on the bike but it was dang near 70 miles of twisties! My friends riding a variety...
Forum: Zongshen RX3 03-23-2016, 10:53 PM
Replies: 4
Views: 1,436
Posted By RX3James
Broken mirror base

Good evening everyone!

I noticed the other day that the base of my right mirror had a large crack running through it and looks to be on the verge of breaking off. I sent an E-mail to Gerry who...
Forum: Zongshen RX3 12-19-2015, 10:09 PM
Replies: 17
Views: 5,080
Posted By RX3James
Checked the MAP/MAT sensor today. It looked clean...

Checked the MAP/MAT sensor today. It looked clean and free of oil and contamination. Since I was in there I took another look at the valve clearances and they seem to be exactly where I set them a...
Forum: Ride Reports 12-17-2015, 09:33 PM
Replies: 92
Views: 18,430
Posted By RX3James
It was 37 at my house this morning. I decided to...

It was 37 at my house this morning. I decided to brave the extreme cold and ride to work any way :D SoCal feels a lot colder this year than last year....
Forum: Zongshen RX3 12-16-2015, 08:20 PM
Replies: 17
Views: 5,080
Posted By RX3James
Today I checked battery voltage. It's good to go....

Today I checked battery voltage. It's good to go. I think the valves are probably good as well. they're not making any strange noises or tapping too loud. I am going to explore the ignition switch...
Forum: Zongshen RX3 12-15-2015, 11:57 PM
Replies: 17
Views: 5,080
Posted By RX3James
Also... I've done the diagnostic check and it...

Also... I've done the diagnostic check and it didn't give me any blinking lights or do anything other than the normal display and start up procedure.
Forum: Zongshen RX3 12-15-2015, 11:53 PM
Replies: 17
Views: 5,080
Posted By RX3James
The battery is only a few weeks old and it came...

The battery is only a few weeks old and it came from batteries plus with a two year warranty. I haven't checked the voltage yet. I'll have to check that tomorrow. I did the valve adjustment about 500...
Forum: Zongshen RX3 12-15-2015, 07:50 PM
Replies: 17
Views: 5,080
Posted By RX3James
RX3 Shut off while riding

OK OK OK....

So today for about the 6th time my RX3 just completely shut itself off electrically while riding. I'm just riding along, the tach goes to zero, the engine shuts off and the red...
Forum: Zongshen RX3 11-30-2015, 12:13 AM
Replies: 103
Views: 20,353
Posted By RX3James
That might very well be true... I only have 1100...

That might very well be true... I only have 1100 miles on my RX3.. I'll wait it out another 900 or so before I commit to a new seat.... It makes me wonder how the guys did on the Western Americas...
Forum: Zongshen RX3 11-29-2015, 11:12 PM
Replies: 103
Views: 20,353
Posted By RX3James
the stock seat....... in my opinion.. it's...

the stock seat....... in my opinion.. it's brutal! I put in 92 miles today on the RX3. I had a great time riding through the twisties and canyons and the Pacific Coast Highway.. I would've put in 200...
Forum: Pure Dirt 11-28-2015, 10:00 PM
Replies: 4
Views: 1,335
Posted By RX3James
Dang! You got me Spud LOL.... Well.. if I was to...

Dang! You got me Spud LOL.... Well.. if I was to purchase this bike it would be solely for off road use..
Forum: Zongshen RX3 11-28-2015, 09:55 PM
Replies: 28
Views: 4,326
Posted By RX3James
I'm happy to report that the installation of the...

I'm happy to report that the installation of the new front rotor and upgraded Chain went very smoothly! Took the RX3 out for a shakedown test ride after and I didn't hear anything at all coming from...
Forum: Pure Dirt 11-27-2015, 10:18 PM
Replies: 4
Views: 1,335
Posted By RX3James
CSC Just anounced their new Zongshen dirt bike!

Looks awesome and at an awesome price too! I'm definitley going to be looking into this bike! I'm sure this one will come with the same amazing customer support that the RX3 comes with. It almost...
Forum: Zongshen RX3 11-27-2015, 09:37 PM
Replies: 28
Views: 4,326
Posted By RX3James
Got my rotor and chain today! wasnt expecting...

Got my rotor and chain today! wasnt expecting them till tomorrow afternoon. Talk about amazing customer service! Gerry was nice enough to throw new rotor bolts in with the new rotor. I'll be...
Forum: Zongshen RX3 11-26-2015, 01:03 PM
Replies: 56
Views: 8,241
Posted By RX3James
My battery failed as well at around 800 miles on...

My battery failed as well at around 800 miles on the bike. I didnt bother calling CSC with that one I just went to batteries plus and bought a much higher quality battery with a 2 year warranty....
Forum: Zongshen RX3 11-26-2015, 12:55 PM
Replies: 28
Views: 4,326
Posted By RX3James
Ok Fellas.. I got ahold of CSC! I spoke with...

Ok Fellas.. I got ahold of CSC! I spoke with Gerry. They are sending me a new front rotor with 6 new rotor bolts and after a really good discussion with him I purchased the EK 520x110 SRO6 upgraded...
Showing results 1 to 25 of 35
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -4. The time now is 08:58 PM.

Contact Us - ChinaRiders.net - Archive - Top

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.