Forum: Dual Sport/Enduro
10-12-2022, 08:55 PM
|
Replies: 0
Views: 574
Handlebar vibration damper
A fishing weight the size of a small egg, flattened with a hammer and screwed to the end of the handlebar. I did one side only, and compared it to the other side with the engine racing. It reduces...
|
Forum: Dual Sport/Enduro
07-24-2022, 08:20 PM
|
Replies: 0
Views: 1,071
Anyone know TBR7 spring rate
My front forks are bottoming out with the longest extensions I could jam in. (Took 2 of us to hold it in while starting the nut.) I think I need stiffer springs, but I don't know how stiff. Does...
|
Forum: Dual Sport/Enduro
05-05-2022, 11:53 PM
|
Replies: 15
Views: 2,057
|
Forum: Dual Sport/Enduro
04-21-2022, 10:40 AM
|
Replies: 9
Views: 1,229
|
Forum: Dual Sport/Enduro
04-21-2022, 10:34 AM
|
Replies: 12
Views: 1,753
Same problem. I did a phosphoric acid slosh,...
Same problem. I did a phosphoric acid slosh, followed by Red Kote. (Fuel tank liner.) You can get the phosphoric by the gallon at Home Depot as "Metal Prep." I used it straight, but apparently it can...
|
Forum: Dual Sport/Enduro
04-19-2022, 09:34 AM
|
Replies: 9
Views: 1,229
tank slosh
My tank had some rust too. I sloshed it with phosphoric acid (It's a blue liquid called "Metal Etch and Prime" at Home Depot.) Apparently you don't need it full strength, just a couple of cups then...
|
Forum: Dual Sport/Enduro
04-15-2022, 11:19 AM
|
Replies: 4
Views: 999
Update: Rear reflector
Texas requires a rear reflector, and I'm not sure whether the taillight lens counts, so I mounted the stock reflector under the license plate. It fits perfectly, with a little shaving.
|
Forum: Dual Sport/Enduro
04-15-2022, 11:13 AM
|
Replies: 4
Views: 999
|
Forum: Dual Sport/Enduro
04-14-2022, 08:33 PM
|
Replies: 4
Views: 999
|
Forum: Dual Sport/Enduro
04-14-2022, 05:15 PM
|
Replies: 4
Views: 999
Simple tail mode
IMO, the stock tail is too long. To make your tail look like this, cut off everything that doesn't look like this, then remount the license plate and install standoff license-plate lights ($10 on...
|
Forum: Dual Sport/Enduro
04-13-2022, 04:09 PM
|
Replies: 0
Views: 2,342
|
Forum: Dual Sport/Enduro
04-12-2022, 10:33 PM
|
Replies: 0
Views: 1,788
Clutch grab/judder. Anyone found a solution?
My clutch grabs and judders on takeoff, instead of smoothly engaging. Good oil helped, but it's still annoying. Apparently this problem is common for many decades across many machines. Does anyone...
|
Forum: Pit/Pocket Bikes & Scooters
04-12-2022, 09:31 AM
|
Replies: 3
Views: 479
|
Forum: Dual Sport/Enduro
04-12-2022, 09:25 AM
|
Replies: 1
Views: 548
Help - Fuel sender mount bolts spinning
The fuel sender is held down by four square-head screws caged in a metal bracket. The bracket is welded on, and is not tight enough to keep the screws from spinning. 3 of the nuts are frozen. I tried...
|
Forum: Dual Sport/Enduro
04-09-2022, 11:23 PM
|
Replies: 37
Views: 6,488
|
Forum: Dual Sport/Enduro
04-09-2022, 11:17 PM
|
Replies: 37
Views: 6,488
|
Forum: Dual Sport/Enduro
04-09-2022, 04:00 PM
|
Replies: 23
Views: 6,637
|
Forum: Dual Sport/Enduro
04-08-2022, 09:32 AM
|
Replies: 18
Views: 2,383
|
Forum: Dual Sport/Enduro
04-02-2022, 12:56 PM
|
Replies: 52
Views: 8,306
Changing tubes is likely to be your most...
Changing tubes is likely to be your most frustrating motorcycle repair. You need a prybar to remove the tire, and that's likely to damage the bead. If you use a prybar to reassemble, you're likely to...
|
Forum: Dual Sport/Enduro
04-02-2022, 12:48 PM
|
Replies: 5
Views: 860
|
Forum: Dual Sport/Enduro
04-02-2022, 11:09 AM
|
Replies: 18
Views: 2,383
|
Forum: Dual Sport/Enduro
04-02-2022, 10:55 AM
|
Replies: 5
Views: 860
|
Forum: Pit/Pocket Bikes & Scooters
04-01-2022, 06:36 PM
|
Replies: 2
Views: 503
New muffler was $8
I replaced the massive straight-pipe muffler on my son's 125cc with an 8HP lawnmower muffler. It sounds good, nice and deep and still loud, but not as loud as it was. Also shaved off a couple of...
|
Forum: Dual Sport/Enduro
03-31-2022, 08:10 PM
|
Replies: 2
Views: 729
Here is what to do about rust
If you ever worked in an outdoor steel industry, you might have known this as "Ospho." It's phosphoric acid, and it converts rust into a hard black crust. Just spray it on the rusty bits every week...
|
Forum: Dual Sport/Enduro
03-23-2022, 06:29 PM
|
Replies: 3
Views: 1,607
|