Hellcat VM22 carburetor and 26mm intake realignment

China Rider 27 · 10-11-2020, 09:40 PM

I would check Amazon and Ebay to find the best shipping and prices.

But I used for the spinner which uses a paper gasket between them

https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

but the company I got them from jacked me around on a later order so I might try one from another company with the rubber o ring.

The silicone hose

https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

The other thing I suggest is using a dremel with a sanding flap disk and roughing up the inner diameter of the spinner so fuel does not collect on it as it comes smooth. I just did the circumference when I put it together. It is beveled some on the edges off the circumference, if I take it apart I will rough up that area too. You also need a short piece of 1 1/2 inch PVC drain pipe obtainable at any hardware store to mount the POD filter in the hose. I have had no issues running this setup for several weeks.

10-11-2020, 09:40 PM	#1
China Rider 27 Join Date: Dec 2018 Location: PNW Posts: 982	I would check Amazon and Ebay to find the best shipping and prices. But I used for the spinner which uses a paper gasket between them https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1 but the company I got them from jacked me around on a later order so I might try one from another company with the rubber o ring. The silicone hose https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1 The other thing I suggest is using a dremel with a sanding flap disk and roughing up the inner diameter of the spinner so fuel does not collect on it as it comes smooth. I just did the circumference when I put it together. It is beveled some on the edges off the circumference, if I take it apart I will rough up that area too. You also need a short piece of 1 1/2 inch PVC drain pipe obtainable at any hardware store to mount the POD filter in the hose. I have had no issues running this setup for several weeks.
	1