MSR Shifter out of stock

[michaelmania]

Anyone know where I can actually purchase an MSR shifter for my Hawk?

[Megadan]

I ran into this problem too when I tried to order mine. They didn't have one in stock so they sent me an IMS Shift lever instead.

[JeremyC]

Originally Posted by Megadan

I ran into this problem too when I tried to order mine. They didn't have one in stock so they sent me an IMS Shift lever instead.

I had the same thing happen to me. Ordered MSR, got the IMS. Just search for an IMS flightline for a crf 230. I'm pretty sure that's the one. Oh, and STAY AWAY from the ones for a DRZ400. They use a 13mm spline on the shift shaft, and ours uses an 11mm spline. I mention this because there are several posts floating around here that mention them fitting our bikes, but it's not even close. The IMS shifter has the clamp bolt going into it from the top (the MSR comes up from the bottom) and you'll run into clearance issues.. get an M6 Allen head bolt of the correct length, and it installs with no issues.

[michaelmania]

You mean this one is good?
https://www.amazon.com/MSR-Shift-Lev.../dp/B000VVU88W

[BigWeld]

Originally Posted by michaelmania

You mean this one is good?
https://www.amazon.com/MSR-Shift-Lev.../dp/B000VVU88W

Pretty sure that will fit. Mine is powder coated steel and was only like $14

[JeremyC]

It should fit. I haven't seen anyone use the aluminum ones, but if it's for a 230, it should.

[michaelmania]

Is this the right one? It fits a CRF230 which others have told me to look for.

http://www.ebay.com/itm/Honda-MSR-Sh...F/371937699554

[pcspecialist]

Wish I could be of more help, the one I got is out of stock:

https://www.amazon.com/gp/product/B000WJAVJ4

It is probably the most important mod I've done, the stock one is too short for my big feet. Not only was it awkward shifting with it, it would bruise my foot where it came in contact with it during upshifting.

[Megadan]

Originally Posted by pcspecialist

Wish I could be of more help, the one I got is out of stock:

https://www.amazon.com/gp/product/B000WJAVJ4

It is probably the most important mod I've done, the stock one is too short for my big feet. Not only was it awkward shifting with it, it would bruise my foot where it came in contact with it during upshifting.

That is the exact one I first tried to order. I have big feet too, so extra room is kind of nice to have. Thankfully, the stock shifter on my 2017 Hawk is liveable. It sticks out too far to the side for my liking, but otherwise isn't too badly cramped for my big foot.

[BlackBike]

Originally Posted by pcspecialist

Wish I could be of more help, the one I got is out of stock:

https://www.amazon.com/gp/product/B000WJAVJ4

It is probably the most important mod I've done, the stock one is too short for my big feet. Not only was it awkward shifting with it, it would bruise my foot where it came in contact with it during upshifting.

Your right , I noticed that too. I can feel it more than the original . I think the shifter prong is shorter. I am used to it and will keep it.