Go Back   ChinaRiders Forums > Search Forums
Reload this Page Search Results
Register FAQ Community Calendar Today's Posts Search
Page 1 of 16 1 2311 Last »
Showing results 1 to 25 of 382
Search took 0.03 seconds. Search: Posts Made By: ProDigit
Forum: Street Today, 08:53 PM
Replies: 7
Views: 1,540
Posted By ProDigit
Despite it being a better quality bike than most,...

Despite it being a better quality bike than most, still don't forget to loosen every bolt on this bike you can see, and apply loctite on it.
If you even forget one, you can be sure to find that...
Forum: Pit/Pocket Bikes & Scooters Today, 08:47 PM
Replies: 4
Views: 272
Posted By ProDigit
I'm thinking, if your bike warms up, it also runs...

I'm thinking, if your bike warms up, it also runs a bit richer than cold.

If you jetted the bike too rich, it could die when warmed up.

Though more likely it's a pinched or kinked fuel line.
Forum: Street Today, 08:42 PM
Replies: 4
Views: 149
Posted By ProDigit
You want a Japanese small bike? You're about a...

You want a Japanese small bike? You're about a decade too late.
All their beginner bikes of 250cc now are 300cc and Kawasaki recently upped the 400cc to 500 (450 actually, but they call it a 500)....
Forum: Reviews 03-31-2025, 09:52 PM
Replies: 42
Views: 15,513
Posted By ProDigit
1.8k mile maintenance: Today I found some of...

1.8k mile maintenance:

Today I found some of the rubber washers of the exhaust starting to disintegrate and crack.
Not sure what product would restore the washers or retail whatever is left of...
Forum: Dual Sport/Enduro 03-28-2025, 06:59 PM
Replies: 9
Views: 356
Posted By ProDigit
You can also just change the front tire to a size...

You can also just change the front tire to a size larger.
7% should be the most accurate over reading of the speedo.
So if you can find a tire that's close to 7% taller in outer circumference,...
Forum: Reviews 03-28-2025, 06:56 PM
Replies: 42
Views: 15,513
Posted By ProDigit
With the exhaust mod, the bike starts running...

With the exhaust mod, the bike starts running very lean again at idle and at top speed, to the point where it's almost the same as before the whole O2 sensor delete.
This due to some of the...
Forum: Dual Sport/Enduro 03-25-2025, 08:30 PM
Replies: 5
Views: 2,741
Posted By ProDigit
I ended up taking the seat off, undo the staples,...

I ended up taking the seat off, undo the staples, and add some foam padding.
Restapled it, added more foam, covered it with a 3d mesh seat cover to keep it in place. My seat now is probably 35"...
Forum: Street 03-25-2025, 02:22 PM
Replies: 4
Views: 5,115
Posted By ProDigit
I would've just swapped to a 428 chain setup. ...

I would've just swapped to a 428 chain setup.
A 520 seems a bit heavy for that bike, and would definitely eat a single digit HP.
Forum: Reviews 03-23-2025, 06:17 PM
Replies: 42
Views: 15,513
Posted By ProDigit
https://i.ibb.co/933GBYv9/20250323-172956.jpg ...

https://i.ibb.co/933GBYv9/20250323-172956.jpg

The 3x 1/2" holes in the exhaust made the engine vibrations smooth out, and the bike overall feels much smoother, despite the O2 bolt showing the...
Forum: Reviews 03-23-2025, 12:12 PM
Replies: 19
Views: 8,714
Posted By ProDigit
Did some tests on the 370mm Akrapovic exhaust,...

Did some tests on the 370mm Akrapovic exhaust, and it's still too much back pressure at 100mph.
I only have a tiny fraction of material left to remove on the top hole, as I maxed out the bottom...
Forum: Reviews 03-22-2025, 07:45 AM
Replies: 42
Views: 15,513
Posted By ProDigit
Not sure but most China bikes use the clutch...

Not sure but most China bikes use the clutch switch and sidestand peg switch (in combination with the gears) to determine if it's safe to fire up the bike.

I also noticed that it takes the system...
Forum: Reviews 03-21-2025, 07:29 PM
Replies: 42
Views: 15,513
Posted By ProDigit
At first I just unplugged it. However, it's...

At first I just unplugged it.
However, it's still blocking exhaust flow by 10-15% even with just 2 or 3 turns in.

So I totally removed it, and plugged the hole with an M12 x 1.25 (standard M12...
Forum: Reviews 03-20-2025, 10:20 PM
Replies: 42
Views: 15,513
Posted By ProDigit
Irate I capped off the O2 sensor hole with a M12 x 1.25...

I capped off the O2 sensor hole with a M12 x 1.25 bolt.
I needed to use a 14mm nut as spacer, as the bolt was slightly too long.
My fuel mileage after the O2 sensor delete is roughly 5% worse...
Forum: Reviews 03-18-2025, 07:09 PM
Replies: 42
Views: 15,513
Posted By ProDigit
Unleash your Lifan Xpect, by running base fuel map.

I'm running the Xpect with the O2 sensor unplugged.
The engine definitely increased in torque, which also increased vibrations slightly, and definitely will lower mpg.

The exhaust smell smells...
Forum: Reviews 03-18-2025, 07:07 PM
Replies: 42
Views: 15,513
Posted By ProDigit
Yes

Yes
Forum: Reviews 03-16-2025, 11:15 AM
Replies: 42
Views: 15,513
Posted By ProDigit
1500 mile maintenance: Chain clean and lube,...

1500 mile maintenance:

Chain clean and lube, and refill fork oil.
Forks needed about 40ml of oil, 20 of that was heavy duty fork oil, the other 50% was 10 weight.
The bolts on the triple tree...
Forum: Dual Sport/Enduro 03-15-2025, 09:55 PM
Replies: 23
Views: 13,919
Posted By ProDigit
For a 300, a pe32mm or PZ32 is more than enough,...

For a 300, a pe32mm or PZ32 is more than enough, unless it's an overhead cam engine with 10+k rpm.
Forum: Adventure Bikes 03-15-2025, 09:47 PM
Replies: 15
Views: 7,594
Posted By ProDigit
490lbs sounds great to you? The CFMoto 450 nk...

490lbs sounds great to you?
The CFMoto 450 nk weighs only 385, 365 with some weight saving mods. I'm sure some cases don't add 100lbs of weight to it
Forum: Reviews 03-15-2025, 09:18 PM
Replies: 42
Views: 15,513
Posted By ProDigit
Today I drilled out the pilot hole under the...

Today I drilled out the pilot hole under the exhaust tip, on the muffler can, for more airflow and noise, with a 3/4 inch and later with a 7/8 in.

This small modification resulted in only slightly...
Forum: Reviews 03-08-2025, 07:43 PM
Replies: 42
Views: 15,513
Posted By ProDigit
I swapped the 38T rear sprocket back to the 36t...

I swapped the 38T rear sprocket back to the 36t sprocket, as the 38t kept the RPMs past the HP curve.

Additionally, I installed a small oil cooler, as a secondary way to keep the oil cool.
It's...
Forum: Reviews 03-08-2025, 02:16 PM
Replies: 42
Views: 15,513
Posted By ProDigit
$.50 ct performance upgrade, O2 sensor.

Today, I tackled two key issues with my CG250, effectively 'killing two birds with one stone.' My bike was overheating at idle, especially in hot (+80F) weather, and I was also looking to boost its...
Forum: Reviews 03-01-2025, 07:19 PM
Replies: 42
Views: 15,513
Posted By ProDigit
I took the Lifan Xpect out of the shed, now that...

I took the Lifan Xpect out of the shed, now that the Vader 150 is waiting for an engine transplant.

The tires lost pressure from 33psi to 14psi since last used (which according to fuelly, is...
Forum: Reviews 03-01-2025, 07:10 PM
Replies: 54
Views: 44,567
Posted By ProDigit
Vader/Condor 150

The 300cc BBK on the 223cc cg250, was a total failure.
I bought several that didn't fit.
Even the ones with a 15mm wrist pin diameter didn't fit.
The piston ended up being jammed in the engine,...
Forum: Street 02-15-2025, 11:37 AM
Replies: 12
Views: 9,430
Posted By ProDigit
Anyone has info on the brake pads of the...

Anyone has info on the brake pads of the Vader/condor 150, and if they are the same as the pads on the Vader 125?
Forum: Dual Sport/Enduro 02-12-2025, 06:00 AM
Replies: 15
Views: 1,813
Posted By ProDigit
Not sure why the hawk won't be a good bike. I...

Not sure why the hawk won't be a good bike.
I got the Lifan Xpect 200, but never use it for the trails. It rides nice and plush for the road, but it's a bit heavier than the hawk.

If you ask...
Showing results 1 to 25 of 382
Page 1 of 16 1 2311 Last »

 
Forum Jump

All times are GMT -4. The time now is 10:33 PM.

Contact Us - ChinaRiders.net - Archive - Top

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.