Delphi MT05 sequence for imperial/metric

brixtonrider · 12-07-2019, 07:53 AM

Is there an ignition key sequence for changing MPH to KPH (imperial/metric) reading for a Delphi MT05 ECU? The bike is a Brixton BX125, had to perform a hard reset of the ECU to clear out a fault code and that switched my clock to miles per hour.

I don't have an OBD2 reader or the right software tools to read/write MCU settings, really hoping there's a sequence for this setting as well.

NzBrakelathes · 12-07-2019, 10:29 AM

Not in ecu I’d say? Weird
I don’t recall seeing it in live data
Prob press button on dash then turn key on..

NzBrakelathes · 12-07-2019, 10:36 AM

The factory guy says turn on off quickly twice

brixtonrider · 12-07-2019, 11:19 AM

Will try that. Thanks a lot, really appreciate it!

brixtonrider · 12-09-2019, 05:57 AM

Many thanks, that worked beautifully.

For clarity to other readers, the full sequence for switching between imperial and metric readings on the dashboard -

1. Turn iginition off for at least 15 seconds
2. Turn ignition on/off two times really quick (half a second or so each cycle)
3. Wait 15 seconds (with ignition off)
4. Turn ignition on, your readings should now be in the new measurement system

12-07-2019, 07:53 AM	#1
brixtonrider Join Date: Dec 2019 Posts: 7	Delphi MT05 sequence for imperial/metric Is there an ignition key sequence for changing MPH to KPH (imperial/metric) reading for a Delphi MT05 ECU? The bike is a Brixton BX125, had to perform a hard reset of the ECU to clear out a fault code and that switched my clock to miles per hour. I don't have an OBD2 reader or the right software tools to read/write MCU settings, really hoping there's a sequence for this setting as well. Last edited by brixtonrider; 12-07-2019 at 10:26 AM.
	0

12-07-2019, 10:29 AM	#2
NzBrakelathes Join Date: Jun 2016 Location: Hell Posts: 2,408	Not in ecu I’d say? Weird I don’t recall seeing it in live data Prob press button on dash then turn key on..
	0

12-07-2019, 11:19 AM	#4
brixtonrider Join Date: Dec 2019 Posts: 7	Will try that. Thanks a lot, really appreciate it!
	0

12-09-2019, 05:57 AM	#5
brixtonrider Join Date: Dec 2019 Posts: 7	Many thanks, that worked beautifully. For clarity to other readers, the full sequence for switching between imperial and metric readings on the dashboard - 1. Turn iginition off for at least 15 seconds 2. Turn ignition on/off two times really quick (half a second or so each cycle) 3. Wait 15 seconds (with ignition off) 4. Turn ignition on, your readings should now be in the new measurement system
	0