Orion Powersports Hawk 250 Experience - so far so good - Page 2

Maadcat · 05-22-2019, 09:23 PM

One final summary now that I have gone through the bike before I swapped out upgrades. Definitely had to go over stuff. A couple of the trim panels weren't fully installed. the rear wheel was set to full rear on one side and 2 notches in on the other. Most everything seemed pretty tight. I went through all of the critical attachments and didn't find anything glaring. So again, I would buy assembled from Orion again for the same price as the other guys. This will be the end of updates on this thread from me other than answering questions. On to the next.....

05-22-2019, 09:23 PM	#16
Maadcat Join Date: May 2019 Location: Holland, MI Posts: 14	One final summary now that I have gone through the bike before I swapped out upgrades. Definitely had to go over stuff. A couple of the trim panels weren't fully installed. the rear wheel was set to full rear on one side and 2 notches in on the other. Most everything seemed pretty tight. I went through all of the critical attachments and didn't find anything glaring. So again, I would buy assembled from Orion again for the same price as the other guys. This will be the end of updates on this thread from me other than answering questions. On to the next.....
	2