Pz30 extended fuel mix screw

[Tt069]

Looking for an extended fuel mix screw fo pz30 any one know which one fits and if so best place to order it. Thnxs

[GronkFries]

The stock one that comes with it is recessed into the base of the carb, but the aftermarket ones could be extended with rubber so it doesn't bend when hit. I might try that...

[NzBrakelathes]

Nothing for Keihin PZ30 but I do sell this tool
https://rover.ebay.com/rover/0/0/0?m...2F303079752722

I’m in NYC tomorrow and can post etc
Postage might be a little more but welcome to contact me

[Tt069]

Thx for the help.
This forum has awesome people

[GronkFries]

Originally Posted by NzBrakelathes

Nothing for Keihin PZ30 but I do sell this tool
https://rover.ebay.com/rover/0/0/0?m...2F303079752722

I’m in NYC tomorrow and can post etc
Postage might be a little more but welcome to contact me

I have one of these tools and they work well, everyone should have them, including the uber expensive Motion Pro (Very little distance between the angle and the driver bit.) The one NZ is selling is priced fairly and should work well.

However, if someone made a rubber contraption that slipped over the idle jet that was grippy enough to turn and flexible enough to deter damage I would buy it hands down. I've made many industry specific enhancements in my day but don't have a lot of time to deal with something like this, so it will probably be an undersized rubber vacuum hose with a filler inside to mitigate the twist.

I will probably make one before that happens but it seems easier than using a tool, and you could do adjustments in the field.