![]() |
#1 |
Join Date: May 2024
Posts: 3
|
need help removing pins from connector
This is the stator wire connector for a Coolster 125cc quad 3125B2. I'm having a problem removing the pins from the connector. Any advice?
Thank you in advance for any help. Dave |
![]() |
![]() |
#2 |
Join Date: Feb 2023
Location: Upstate SC
Posts: 320
|
I didn't watch the video but looked at the picture. You need to pop the yellow piece out with a tiny screwdriver. It is the "lock" that keep s the pins in. The pins are latched by plastic bits you have to pry away from the pin while pulling on the wire. There are purpose made little release tools but you can usually get them with a small sharp pick. The latches are right under where the yellow "legs" are at the pins. The yellow pieces lock the latches by keeping them up against the pins. Once you figure out how to get the first one loose you'll be golden.
__________________
2023 Templar 250 X |
![]() |
![]() |
#3 |
Join Date: Feb 2024
Location: SW Missouri
Posts: 176
|
+1 on Gypsy's advice.
If the connector pins are relatively short you might try a cell phone sim card tray tool to pop the pin retention tab out of the way after removing the yellow part.
__________________
---------- 2023 Templar X 2009 Triumph Bonneville 1976 Yamaha DT175 1974 Honda MT125 |
![]() |
![]() |
#4 |
Join Date: May 2024
Posts: 3
|
Thanks guys! Really appreciate it!
Last edited by Purch23; 05-16-2024 at 02:39 PM. |
![]() |
![]() |
#6 | |
Join Date: May 2024
Posts: 3
|
Quote:
|
|
![]() |
|
![]() |
![]() |
|
|