Vitacci Terminator 300cc 4x4 atv

[dugndeep]

Now I'm looking to purchase a service manual for the Linhai 260/300 4x4 atv.I have a couple already downloaded & saved on my computer but I want a paper back version.I just don't know if my printer could print out 360 pages plus whether I got the ink to do that.

[dugndeep]

I've been going around the atv trying to find all the zerk grease fittings and applying some grease to them.I think I have found them all & am now wondering about the front hub carrier bearings.Their like the old cars & tractors ect & their not a sealed bearing.

[dugndeep]

The 2wdhub carrier looks like it has a place for a zerk fitting.To where the 4wd does not,I was just wondering if I could drill & tap for a zerk fitting?

[JerryHawk250]

I would drill and tap it to install a grease zerk.

[dugndeep]

That's the 2wd version above & I don't know if that is a threaded hole for the zerk fitting or not.The 4wd doesn't have that & has the splined shaft running through it.

[dugndeep]

I suppose you might could on the back side of the rotor.

[dugndeep]

I think they skimped on the grease in the fittings,some I don't think they put any grease in & that's why I'm worried about the front axle bearings.

[dugndeep]

I'll have to take the wheel off,cotter pin & nut just to see what kind of grease is in there.There's a grease fitting on the steering shaft,I had to take the front cover off to get to it & they must have never put any grease in it,so much easier to steer after putting grease in the steering bushing.

[JerryHawk250]

As long as the zerk doesn't interfere with the bearings or shaft, I wouldn't think you would have any issues with installing one.

[dugndeep]

Parts catalog.I'm trying,one picture is to big & the other is so small you can't hardly see it.I'll just have to take the hub carrier off to see.

[ndlangub]

dugndeep

Can you eShare the Service manual with Parts Catalog for the Vitacci Terminator aka Linhai LH300? Needing to get a full replacement Transmission, so need the service manual parts numbers - another ATV rear ended me and the transmission is now stuck in HI gear and won't slip into Neutral or Reverse any longer.

Then will need to research where I can buy the replacement transmission.

[buzz]

ndlangub good luck finding parts for this 4 wheeler,was thinking of buying one. Until i started looking for parts,no good.

[JerryHawk250]

Parts are available from the dealer and also can be found on AliExpress. Linhai is the actual manufacturer.

[buzz]

What dealer has parts in stock for this 4 wheeler? Where are they located at? Do you have one of these, and what does a rebuild kit for the engine cost. Thanks

[JerryHawk250]

Originally Posted by buzz

What dealer has parts in stock for this 4 wheeler? Where are they located at? Do you have one of these, and what does a rebuild kit for the engine cost. Thanks

The distributor Vitacci and Rickey Powersports carries parts. You have to go through the dealer you buy it from to get them. I did a quick search on Aliexpress and found plenty of engine parts for probably less if you don't mind waiting.