05-18-2016, 02:19 PM | #1 |
Join Date: May 2016
Posts: 583
|
Hawk upgrades, mods and accessories
I cut off the buckles (leaving the loops intact) and drilled some holes in the seat pan to get a Coleman Comfort Ride(TM) Seat Protector to fit like a glove. http://www.amazon.com/dp/B006JMK7N8
Code:
http://www.amazon.com/dp/B006JMK7N8 Trunk fit beautifully, just needed some large nuts to raise it enough that I can get the seat on and off and the rear slots had to be filed a little bit to line up with the bolt holes on the Hawk. The trunk is easily removed, just turn the key and press a button. Now I just need a tank bag and some saddle bags. http://www.ebay.com/itm/351721854900 12" X 3.5" OWNER MANUAL CANISTER http://www.ebay.com/itm/111693466254 NGK (2202) DPR8EIX-9 Iridium IX Spark Plug http://www.amazon.com/dp/B000CSGWZC MSR DR-Z400 shifter (1 inch longer than stock) http://www.amazon.com/dp/B000WJAVJ4 With the stock carb, I removed the plug over the idle mixture screw and turned it out 1 3/4 turns. I used a center punch to indent and then tap off the tamper proof screws, shimmed up the needle with three #4 washers and replaced the main jet with a large round size 110 (N100.604/110). http://www.ebay.com/itm/171069472877 Replaced the front sprocket with a 17 tooth one. Discovered you can't get the cover back on with the chain on the 17 tooth, have to put the chain on after the cover is installed. http://www.amazon.com/dp/B004DNA0KA Last edited by pcspecialist; 05-19-2016 at 08:49 PM. |
|
|
|
|
|