Upgraded Kickstand for Hawk 250 DLX?

SirPorl · 10-07-2024, 02:48 AM

Anyone upgrade their kickstand? These bikes lean over quite low and the metal quality of the stock ones is suspect. My Hawk DLX kickstand snapped tonight. Wondering if there is anything better out there.

Thanks

Do©Hawk · 10-07-2024, 03:45 PM

Snapped? Were you riding or parked?

SirPorl · 10-07-2024, 04:32 PM

While parked. Nothing like having to pick up the bike in a parking lot. While heavy for a 250, not that heavy.

It snapped at the weld. Just curious if anyone has found anything better. My ability to fabricate is limited.

slithica · 10-20-2024, 11:38 PM

I looks like someone broke it. It doesn't look like a weld failure, not fully anyway.

I would just say to take the other part off and weld them back together. Other than that just buy a new stock one.

10-07-2024, 02:48 AM	#1
SirPorl Join Date: Jun 2023 Posts: 6	Upgraded Kickstand for Hawk 250 DLX? Anyone upgrade their kickstand? These bikes lean over quite low and the metal quality of the stock ones is suspect. My Hawk DLX kickstand snapped tonight. Wondering if there is anything better out there. Thanks
	0

10-07-2024, 03:45 PM	#2
Do©Hawk Join Date: Oct 2023 Location: Western PA Posts: 310	Snapped? Were you riding or parked? __________________ 2022 Hawk DLX EFI * 17T Front / 47T Rear / 428 x-ring chain * Kenda K-760 front + rear * Banjo brake light switch * LED headlight + front turn signals * Custom cutting board skid plate * Debadged (I don't like to brag about the superior strength!) * Top speed, GPS verified, as equipped: 68 mph (so far)
	0

10-07-2024, 04:32 PM	#3
SirPorl Join Date: Jun 2023 Posts: 6	While parked. Nothing like having to pick up the bike in a parking lot. While heavy for a 250, not that heavy. It snapped at the weld. Just curious if anyone has found anything better. My ability to fabricate is limited. Attached Thumbnails Last edited by SirPorl; 10-07-2024 at 09:20 PM.
	0

10-20-2024, 11:38 PM	#4
slithica Join Date: Jan 2021 Posts: 49	I looks like someone broke it. It doesn't look like a weld failure, not fully anyway. I would just say to take the other part off and weld them back together. Other than that just buy a new stock one.
	0