New here and need help finding a specific sprocket

[oenvii]

Hello all,

I purchased a 2020 Bashan Enforcer last fall. Absolutely love it. I'm in the process of the sprocket upgrade and am having issues finding the proper rear for a 428 pitch 45t. My sprocket is offset and I have only found one that is similar. The issue is mine is a 4 pin connector, theirs is 6. I was hoping someone here would know what I could do.

This is the sprocket I could buy but has a 6 pin connection:https://www.ebay.com/itm/35326262729...m=353262627290

Any tips would be great. Thanks!
Also, I've tried a standard sprocket. Does not line up with the front if it's not offset.
Attached is a pic of my current sprocket.

[Falkon45]

Welcome!!! I'm not really sure about if it fits your bike. If you look around for your factory sprocket, I'm sure you can find the original measurements. I will say this though... You've helped me find a possible sprocket for the KPM 200

[TxTaoRider]

Is there enough thread on the studs to use thick washers?

[Falkon45]

Originally Posted by oenvii

Hello all,

I purchased a 2020 Bashan Enforcer last fall. Absolutely love it. I'm in the process of the sprocket upgrade and am having issues finding the proper rear for a 428 pitch 45t. My sprocket is offset and I have only found one that is similar. The issue is mine is a 4 pin connector, theirs is 6. I was hoping someone here would know what I could do.

This is the sprocket I could buy but has a 6 pin connection:https://www.ebay.com/itm/35326262729...m=353262627290

Any tips would be great. Thanks!
Also, I've tried a standard sprocket. Does not line up with the front if it's not offset.
Attached is a pic of my current sprocket.

Actually, I've read your post again. No, would will not be able to use a 6 bolt sprocket on the 4 bolt sprocket.