Question for Apollo DB36 250 Owners...What is this part?

[Ski_rush]

I'm about ready to start building the new bike tomorrow. It's out of the crate and on the lift. Front wheel is on.

I went through all of the parts. I came across this part (see pics below) and I can't quite figure out where it goes. I'm sure it's something simple that I should have known, and I might have figured it out as I started actually assembling.

At the risk of looking like an idiot, I thought it would just be much easier to ask here and get the right answer. I was thinking it was a suspension bushing, but can't quite figure it out.

Here it is:

[512customs]

Looks like a chain roller

[Its_not_a_honda]

Chain roller. Goes on a little tab/bracket near the kickstand bolt. You should have a bolt with it somewhere. It goes near the swing arm pivot and keeps the chain from flopping up and down. It isn’t real obvious and the instructions (as I remember) don't mention it.

[Ski_rush]

Originally Posted by Its_not_a_honda

Chain roller. Goes on a little tab/bracket near the kickstand bolt. You should have a bolt with it somewhere. It goes near the swing arm pivot and keeps the chain from flopping up and down. It isn’t real obvious and the instructions (as I remember) don't mention it.

Thanks, that helps quite a bit. I’m not sure I would have figured that out. I don’t think my other bike had that.

[JerryHawk250]

I would say that's a remote on the right. lol
Wait, It comes with a hatch back too???

But seriously the chain roller is a nice feature. Wish the Hawk had one. I've looked at retrofitting one on mine. The chain guide on the Hawk isn't the greatest. I had to modify it just to make it like up with the chain.