03-26-2008, 12:25 PM | #1 |
Join Date: Jun 2007
Posts: 162
|
carb help!!
so I finally took the carb apart last night, found some shit in the bowl, cleaned it out, and put it back together.
but now when I turn the gas on the carb floods and spills over. also the throttle cable has some slack and turning the bike on will make it flood/rev real high. I think I installed that little tube the needle sits in wrong. how is it supposed to go? I dont think mine goes to the very bottom. also my needle was set to the highest point. how far down should the slide thing go? |
|
03-26-2008, 01:19 PM | #2 | |
Re: carb help!!
Quote:
|
||
|
03-26-2008, 01:27 PM | #3 |
Join Date: Jun 2007
Posts: 162
|
after looking at this
http://www.chinariders.net/gallery2/...serialNumber=2 I think I put in #4 in wrong :( AJSFHKJASDHK:JASHDKJASHDKJHASDLK WHAT A PAIN!!!!!! :( :( because of the throttle cable its such a bitch to get that part out :( |
|
03-26-2008, 01:38 PM | #4 |
Join Date: Apr 2007
Location: Show Low Arizona
Posts: 2,889
|
You're going to get good at taking that carb off
Sucks when things like that happen...I usually wind up doing everything twice.
__________________
<br />2001 Suzuki DR200SE<br />1997 Suzuki RM250 YIKES<br />1995 Yamaha Breeze 125 daughters<br />1991 Honda XR80r Restored<br />maybe a 2003 Yamaha TTR90 |
|
|
|
|
|