250cc Hawk Modifications (The Necessities) - Page 2

**JerryHawk250** · 03-30-2017, 11:29 AM

Quote:

Originally Posted by JustAdam

So does the blue light operate when the turning signal is engaged or is it on constantly as a running light?

The blue light has its own wire so you could hook it up either way.

Merlin · 03-30-2017, 11:30 AM

It's intended to be a running light but you can set it up any way you like. Ill set mine up as running lights

Gunrunner Doc · 04-11-2017, 10:28 PM

Ariel, not sure what an "ASIN" is, but it's the closest thing to a serial number I've found: ASIN B0176TA1H4. Otherwise, it's just labeled as "VM26 High Performance Carb" on Amazon.

Gunrunner Doc · 04-20-2017, 09:00 PM

Another update, couple more parts. And finally calculated my average mpg at 74.6.

Finally got around to getting a Uni pod filter. Couldn't find one that was exactly 42mm, but the 44mm fit just fine. It's a little squished under the plastic body, but it works out just fine. Unfortunately, I'm pretty sure that I need to rejet to a 130 now. As for oil, I just bought the stuff Uni sells on Amazon. I thought I was wasting money on that oil, but turns out that it really does have its own unique consistency. It's more like gear paste in aerosol form.
http://a.co/c6trxrw

New chain, which was much-needed. I wanted to get the one Motocheez did a video on, but they didn't have it on Amazon. Did a little searching and settled on a D.I.D. 428VX x-ring chain. Came with everything I needed, just had to cut a few links out. It came with 130 links, which would probably be fine for you guys who didn't go down much on your rear sprocket, but don't quote me on that.
http://a.co/2orCizR

While I was under there, I noticed that my tire has been rubbing against the muffler of the new exhaust. No damage except for smoother knobs on one side. Moral of the story, if you're going to do the exhaust upgrade, be sure to add washers if you need to for some lateral clearance.

dpl096 · 04-20-2017, 09:16 PM

Motocheez is a good guy and damned knowledgeable on the Hawk...actually bikes in general.

Ariel Red Hunter · 04-20-2017, 11:22 PM

Quote:

Originally Posted by Gunrunner Doc

Ariel, not sure what an "ASIN" is, but it's the closest thing to a serial number I've found: ASIN B0176TA1H4. Otherwise, it's just labeled as "VM26 High Performance Carb" on Amazon.

I was refering to a model number, such as "VM-26-1076". I'll have to find the book which gives the float height measurements, so that you can check them...ARH

03-30-2017, 11:30 AM	#17
Merlin Join Date: Jun 2016 Location: Colorado Posts: 1,107	It's intended to be a running light but you can set it up any way you like. Ill set mine up as running lights __________________ Bashan Blaze Mods: Alloy Rim's, Muffler, Mukuni VM26 Carb, Foam Filter, Tachometer, Volt Meter,LED Headlight, LED Blinkers
	1

04-20-2017, 09:00 PM	#19
Gunrunner Doc Join Date: Jan 2017 Posts: 9	Another update, couple more parts. And finally calculated my average mpg at 74.6. Finally got around to getting a Uni pod filter. Couldn't find one that was exactly 42mm, but the 44mm fit just fine. It's a little squished under the plastic body, but it works out just fine. Unfortunately, I'm pretty sure that I need to rejet to a 130 now. As for oil, I just bought the stuff Uni sells on Amazon. I thought I was wasting money on that oil, but turns out that it really does have its own unique consistency. It's more like gear paste in aerosol form. http://a.co/c6trxrw New chain, which was much-needed. I wanted to get the one Motocheez did a video on, but they didn't have it on Amazon. Did a little searching and settled on a D.I.D. 428VX x-ring chain. Came with everything I needed, just had to cut a few links out. It came with 130 links, which would probably be fine for you guys who didn't go down much on your rear sprocket, but don't quote me on that. http://a.co/2orCizR While I was under there, I noticed that my tire has been rubbing against the muffler of the new exhaust. No damage except for smoother knobs on one side. Moral of the story, if you're going to do the exhaust upgrade, be sure to add washers if you need to for some lateral clearance. Last edited by Gunrunner Doc; 04-20-2017 at 09:04 PM. Reason: added mpg
	0

04-20-2017, 09:16 PM	#20
dpl096 Join Date: Sep 2015 Location: East Central Hellinois Posts: 1,344	Motocheez is a good guy and damned knowledgeable on the Hawk...actually bikes in general. __________________ ************************************************ * " Time you enjoy wasting, is not wasted." - John Lennon “I predict future happiness for Americans, if they can prevent the government from wasting the labors of the people under the pretense of taking care of them.” ― Thomas Jefferson "If you don't know where you're going any road will take you there" ....George Harrison song
	1

04-11-2017, 10:28 PM	#18
Gunrunner Doc Join Date: Jan 2017 Posts: 9	Ariel, not sure what an "ASIN" is, but it's the closest thing to a serial number I've found: ASIN B0176TA1H4. Otherwise, it's just labeled as "VM26 High Performance Carb" on Amazon.
	0