10-02-2015, 12:54 PM | #1 |
Banned
Join Date: Sep 2015
Posts: 176
|
Front and rear axle nuts. What size?
Title says it all. Anyone?
|
|
10-02-2015, 02:03 PM | #2 |
Banned
Join Date: Sep 2015
Posts: 176
|
not looking at thread size or pitch...just the outer nut size
|
|
10-02-2015, 04:25 PM | #3 |
Join Date: Jul 2008
Location: Idaho
Posts: 25,054
|
I believe the front axle nut fits a 19 mm socket. I always use a pair of crescent wrenches to remove the rear axle.
__________________
Spud "Never argue with an idiot. He will drag you down to his level, and beat you with experience." Mark Twain 2015 Zongshen ZS250GY-3 (RX3) 2006 Zongshen ZS200GY-2 (Sierra 200) 2005 Honda XR650L 2004 Honda CRF250X 1998 Kawasaki KDX220 Mods made to my Zongshen ZS200GY-2: http://www.chinariders.net/showthread.php?t=6894 |
|
10-02-2015, 04:39 PM | #4 |
Join Date: Sep 2014
Location: Orange County, CA
Posts: 410
|
On the rear, it is 17mm (nut) and 18mm (bolt head) per the CSC tutorial:
http://www.cscmotorcycles.com/Articles.asp?ID=257 |
|
10-02-2015, 06:21 PM | #5 |
Join Date: Jul 2015
Location: Milpitas, CA. USA
Posts: 775
|
Just went out & measured.
Both front & rear axle nuts are 19mm, 3/4" will also fit (I tested). Rear axle head is 18mm. 11/16" may or may not fit, depends on tolerance of the wrench/socket. Hope this helped. ________________________ If it doesn't say "Made in China" it's probably counterfeit. |
|
10-02-2015, 10:52 PM | #6 |
Join Date: Sep 2014
Location: Orange County, CA
Posts: 410
|
Thank you, Jay! You are correct 19mm nuts, 18mm bolt head (rear only).
|
|
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|