No spark Boom Vader
So I just figured out that I had a bad wire in the harness for my tach, and when I replaced the wire both my tach and kill switch started working normally (the kill switch didn't do anything before). It ran well for a few minutes, but when I turned it off then back on again, it cranks over but won't start. I have no visible spark at the plug now. I tested the continuity of the kill switch, and the resistance of the ignition coil, and both seem normal. The continuity of the wires between the coil and the cdi seem ok too. It's possible I messed up another wire when moving around the harness, but I'm not sure what else to test...any help from the gurus here would be greatly appreciated!
|