08-05-2022, 07:37 PM | #13 |
Join Date: Jan 2022
Location: Weed, California.
Posts: 271
|
Hay Lukas ! I can't figure out how to modify a data point like say the Idle preset table
if I click on the point it says "error you must select a calabration table to use with this" I go down and try to select a calibration table but it takes me to the calibration table and does not add it to the idle preset section .... maybe I have to be connected to the bike ? .... getting to know this program is harder than tearing down the bike ! LOL there is so much useless information in the ECU that it is unreal but the ECU needs that stuff to make it's calculations..... do you know of a video on how to get the calibration tables to work on the program ? .....(i've done what the guy did in the above video showed, but it doesn't do anything it just shows his calibration table that you cannot use) Bob........
__________________
It's too late when you've gone too far ! Last edited by Bob Kelly; 08-05-2022 at 10:02 PM. |
|
|
|
|
|