Quote:
Originally Posted by rjmorel
So I'm finally getting around to installing the 300 kit bought several months back. Question I have is can it be installed with motor in frame? Do you have to loosen engine mounting bolts and tip it down to get top end off? They really had to cram stuff in there to get all the technology to work.
I miss my Hodaka. 
Also I did a compression test on it cold after sitting for a week with throttle help wide open. Only got 100psi out of it . I think it should be closer to 125-135 to run good. Mine has always ran good but didn't seem to have the power of other RX3s on the trips when I've rode with them.
thanks rj |
It will just work if you ONLY remove the frame part around the engine - no need to remove the engine.
Stick tongue out to the left to get the top of the motor off
11-29-2018, 01:25 AM
Threaded Mode