No rear brakes on my beast.

TYE · 07-02-2013, 10:17 PM

I recently changed the hydraulic fluid in the rear brake on my beast. I did this the reverse method with a syringe. So I opened the reservoir and drain it. Then opened the bleeder and fead new fluid through the entire system until all air and old fluid was out. Closed the bleeder and now lost brake pressure? I don't think there is any air in the system and nothing is leaking but I cannot build up any pressure when pumping the brake pedal.i did all this after replacing the rear pads? I'm not sure if there's a way to check the master cylinder?

07-02-2013, 10:17 PM	#1
TYE Join Date: May 2010 Location: waterdown Posts: 90	No rear brakes on my beast. I recently changed the hydraulic fluid in the rear brake on my beast. I did this the reverse method with a syringe. So I opened the reservoir and drain it. Then opened the bleeder and fead new fluid through the entire system until all air and old fluid was out. Closed the bleeder and now lost brake pressure? I don't think there is any air in the system and nothing is leaking but I cannot build up any pressure when pumping the brake pedal.i did all this after replacing the rear pads? I'm not sure if there's a way to check the master cylinder? __________________ modsz30 carb, 110 main,22.5 pilot,ngk race coil wire and plug dr8es-l, no rev cdi, monster muffler
	0