Building an high comp OHC

[RageHardIntoTheBendies]

OK Been sick for the last week so I've been sitting at home researching engine combo's as I want a bit more power in my Saga.

Was originally thinking of doing the XR200 swap but these motors are becoming hard to find.

I think I have come up with a good recipe for a high compression OHC that should make good power. LT230 10.5:1 overbore weisco piston with LT250s cams.
Looking for the OHC with a 66mm bore same as is used in the xf200 (what is the code for that 166fmm?)

I have found hooper http://www.hooperimports.com/product..._id=200ccV%2DH but that is a 163fml with a 63mm bore.

I have also seen a 169fmm http://www.crossfiremotorcycles.com/...engine-4t.html But that uses a 15mm wrist pin like the XR200 but I doubt the suzuki cams would work. I Guess it's possible the Xr200 cams would work in that

Anyone know of a good supplier in the north west? Or have a used OHC they would part with?

I'm going to try EMailing some of the Konker dealers to see what they have to say.