10-04-2013, 11:30 PM | #1 |
Join Date: Mar 2009
Location: Southeastern Washington desert
Posts: 14,761
|
Kick start lever, GY2 needed.
My GY's kickstart lever is a little floppy. The little ball indent it not properly made and it flops irritatingly against my leg while riding. No biggie but does anyone have a better kickatart lever I can buy?
Also, the kickstand on this thing is about an inch (or more) shorter than I would like it for security against falling over, especially in the dirt. My guess is that it was made for a bike with smaller wheels. Does anyone have a longer kickstand? I may resort to mailing it off to Weld and ask for a favor ;-)
__________________
Happy to serve. |
|
10-05-2013, 01:04 PM | #2 |
Join Date: Jul 2008
Location: Idaho
Posts: 25,054
|
I would check eBay, Hooper Imports, and Roketa.com for both items.
__________________
Spud "Never argue with an idiot. He will drag you down to his level, and beat you with experience." Mark Twain 2015 Zongshen ZS250GY-3 (RX3) 2006 Zongshen ZS200GY-2 (Sierra 200) 2005 Honda XR650L 2004 Honda CRF250X 1998 Kawasaki KDX220 Mods made to my Zongshen ZS200GY-2: http://www.chinariders.net/showthread.php?t=6894 |
|
10-05-2013, 07:03 PM | #3 |
Join Date: Mar 2009
Location: Southeastern Washington desert
Posts: 14,761
|
I was planning on that but wanted to see if someone here wanted to sell one thta may have been sitting around first. No rush ;-)
__________________
Happy to serve. |
|
10-05-2013, 09:25 PM | #4 |
Join Date: May 2007
Location: Altamont, Kansas
Posts: 15,103
|
Weld may have an xr lever. It should be pretty easy to cut the kickstand and weld a short piece of pipe into the kickstand.
__________________
You meet the nicest people on a Honda Clone. |
|
10-06-2013, 12:24 PM | #5 |
Join Date: Mar 2009
Location: Sardis, BC, Canada
Posts: 25,977
|
Have you tried to repair the kicker? I've had worn out kickers in the past, and I've shimmed the spring and stamped the ball into the seat to improve the detent. Install an o-ring between the swivel and the base for some added friction. Slather the mechanism with some heavy axle grease and you should have the resistance you need.
I might have a spare kicker, but it depends on the specific shape of yours. I've seen a few different shapes on Honda clones. I'm happy to extend your kickstand for you. Just LMK.
__________________
Weldangrind "I figure I'm well-prepared for coping with a bike that comes from the factory with unresolved issues and that rewards the self-reliant owner." - Buccaneer |
|
10-06-2013, 05:59 PM | #6 |
Join Date: Jun 2013
Location: Cumming, GA
Posts: 303
|
Mine does the same thing, and it only had 49 miles on the od. I think it is a standard Lifan 163fml.
|
|
10-06-2013, 09:35 PM | #7 | |
Join Date: Mar 2009
Location: Southeastern Washington desert
Posts: 14,761
|
Quote:
If I get a chance I'll try to follow your advise on repairing the kicker :-)
__________________
Happy to serve. |
|
|
|
|
|
|