|
04-20-2007, 01:59 PM | #1 |
Join Date: Mar 2007
Location: massenaNY
Posts: 25
|
egr valve
i took the hoses off my bike and it seems to run better. the hose that connects to the side of the motor , i started it up without it being plugged and it runs through the exaust but i crimped the tube and put it back on and it definetly has a lot more balls the throttle seems to be a lot touchier and i will probably get some more compression on my rds-200.
|
|
04-20-2007, 02:05 PM | #2 |
Yes...most of us have disabled or removed that system with good results.
__________________
2009 XR650L Big Red Pig Tusk bar risers 2007 X-Moto(Jetmoto) GY250 --mods--- 15/40 sprockets UNI Pod Filter 2007 Shineray TMS 200XYi--Betsy Betsy Mods:______________________ Acerbis DHH headlight FMF Powercore pipe Uni Pod Filter |
|
|
07-23-2007, 11:54 AM | #3 |
Join Date: Jul 2007
Posts: 11
|
emissions
can any one tell me if taking this stuff of will actually help and do i leave the crankcase breather on ,but take everything else off
|
|
07-23-2007, 12:11 PM | #4 |
Join Date: Oct 2006
Location: 11481 State Route 44 Mantua, Ohio 44255
Posts: 1,112
|
Leave the crankcase breather alone! Do Not plug it or remove it.
__________________
Thanks, Bruce @ Endless Journey Cycles "Phone Calls Only" ~330-274-0098~ Hours: Tue.-Fri. 10:00-6:00 Sat. 10:00-4:00 EST. Dealer for: Lifan, Crossrunner ATVs. http://www.endlessjourneycycles.net |
|
07-23-2007, 01:06 PM | #5 |
Join Date: Jul 2007
Posts: 11
|
egr emissions
will i need to change the needle/clip height or carb setting ??? cause the burn on the plug was a perfect light tan before????I also cannot get any play in the clutch cable ,both adjustments are bottomed out ,bike is brand new will it get better.????
|
|
07-24-2007, 09:25 AM | #6 |
Join Date: Oct 2006
Location: 11481 State Route 44 Mantua, Ohio 44255
Posts: 1,112
|
fishman
What make bike do you have? Yes you will need to re-adjust your carburetor, but I can't tell you what to re-adjust it to because I don't know where you live and what your altitude is. The clutch cable you have on the bike may be too short that's why you don't have any free-play. Will it get better... yes as the clutch plates wear but it may take quite a while. Your best bet is to get a longer clutch cable, but since I don't know what ends are on yours I can't help there would need pics.
__________________
Thanks, Bruce @ Endless Journey Cycles "Phone Calls Only" ~330-274-0098~ Hours: Tue.-Fri. 10:00-6:00 Sat. 10:00-4:00 EST. Dealer for: Lifan, Crossrunner ATVs. http://www.endlessjourneycycles.net |
|
07-24-2007, 12:19 PM | #7 |
Join Date: Jul 2007
Posts: 11
|
egr
i have the orion or viva 250 dirtbike ,and now the seals on the upside down forks are leaking badly and of course no help from the internet site i bought it ,except to sell me new forks or sell me fork seals which are backordered from china, Bike is 3 days old.
|
|
07-24-2007, 02:45 PM | #8 | |
Join Date: May 2006
Location: Fredericton, NB, Canada
Posts: 1,744
|
Quote:
Thanks,
__________________
Frostbite "The beatings will continue until moral improves" |
|
|
|
|
|
|