|
03-25-2016, 05:11 PM | #1 |
Join Date: Apr 2015
Posts: 366
|
prepping a bike for storage??
So...if you know your poor bike /bikes are going to sit idle for a while, what do you feel are critical activities to store them?
Also what constitutes a while? Some point this summer I might not be able to ride for a 4 month stretch... The bike already lives on a tender. and based on standard google consult, I should fill the tank and add a stabilizer - sadly there is no Ethanol-free fuel to be had in these parts that I'm aware of. Anything else critical? |
|
03-25-2016, 05:18 PM | #2 |
Join Date: Jul 2008
Location: Idaho
Posts: 25,054
|
For a 4-month hiatus, I think you have things covered.
__________________
Spud "Never argue with an idiot. He will drag you down to his level, and beat you with experience." Mark Twain 2015 Zongshen ZS250GY-3 (RX3) 2006 Zongshen ZS200GY-2 (Sierra 200) 2005 Honda XR650L 2004 Honda CRF250X 1998 Kawasaki KDX220 Mods made to my Zongshen ZS200GY-2: http://www.chinariders.net/showthread.php?t=6894 |
|
03-25-2016, 05:46 PM | #4 |
Join Date: Dec 2015
Location: CO
Posts: 1,525
|
I would add an ounce or so of Sta-Bil Marine to the gas tank just before you fill it at the gas station, the ride home will be enough to circulate it through the system.
1oz will treat 5 gallons of fuel for clean up and storage purposes up to a year http://www.goldeagle.com/product/sta-bil-360-marine I found a quart bottle at Walmart for under $12 last time I was in there
__________________
"Think as you like... but this self proclaimed Professor is always right" - Buckshot "You never know what someone is hiding beneath their smile..." - NinjaTom - R.I.P. |
|
03-25-2016, 06:08 PM | #5 |
Join Date: Nov 2015
Posts: 34
|
Ideally i think some Sta-Bil in the tank and starting it up once every other week or so would be the way to go, but I would rather drain the fuel if it won't be started up at all during the (up to) 6 months. Sta-bil and the like will keep the gas from turning, but for peace of mind I wouldn't leave fuel in the lines and tank that could potentially leak down and into the case.
I would also put the bike up on a stand (like a MX stand). Keep both the tires off the ground to avoid flat spots. Put some dryer sheets around the electrical wires and in the exhaust pipe to keep any vermin away. Lube up the chain and spin the rear tire every once in a while to keep the links from seizing. |
|
03-25-2016, 06:28 PM | #6 |
Join Date: May 2007
Location: Warshington
Posts: 928
|
All of the above. Will you be away from the bike for the 4-6 months? Or will you still be at the same place bike is so you can go out and give it some TLC even if you can't ride it? Definitely keep the vermin out of exhaust and air cleaner, on and off a battery tender every 2-3 weeks, keep it under a roof so weather doesn't mess things up. Sta-bil the gas and if it's in a garage it should be OK. Better if you can have someone if not yourself go start it every few weeks and let it warm up a bar or two, pull in clutch lever multiple times so plates don't stick together. rj
__________________
Live Zong, and Prosper |
|
03-25-2016, 07:48 PM | #7 | |
Join Date: Apr 2015
Posts: 366
|
Quote:
Unfortunately it sounds like my foot might be in a boot of a different sort at some point this summer (I've got some partially torn tendons that require addressing) and I don't know for sure yet how long it might be before they clear me to stuff my foot into my motorcycle boot after the other boot comes off :P |
|
|
03-25-2016, 06:34 PM | #8 |
Join Date: Oct 2015
Location: FL, GA, NC
Posts: 771
|
My usual practice for storing my bikes in NC for the six months they sit unused is to:
...add stabilizer and fill the fuel tank ...change the oil and filter, so contaminants don't have time to work on internal engine parts ...plug up the exhaust and air box openings to discourage mice from making nests ...check the air filter, clean and lubricate if necessary ...remove the battery, and put it on a battery tender ...jack up the bike to take the weight off the tires so they don't develop flat spots ...do a general cleaning of accumulated road grime, optional wax ...lubricate the chain, best done while warm ...cover the bike with an old bed sheet or breathable bike cover. ...optionally, I usually remove the spark plug and "fog" the cylinder This may seem like overkill, but your bike will be ready for use with minimum fuss when you need it. I don't recommend starting the engine. That only serves to contaminate the oil, and if you do, the engine must be run long enough to "burn off" the accumulated moisture condensation. jb
__________________
2016 Honda CB500F......2017 Triumph Street Twin 2014 XT 250........ |
|
03-26-2016, 03:12 PM | #9 | |
Join Date: Oct 2015
Location: Berthoud, CO
Posts: 205
|
Quote:
Ethanol free gas is a better choice. Locations are listed here:http://pure-gas.org/ (NOTE: that is "pure dash gas".org; without the dash it goes to a malicious website) My preferred gas additive is Star Tron, http://www.starbrite.com/startron, Available at Walmart in the boat supplies section, and other places.
__________________
Dan CSC RX3 Cyclone, CSC TT250, Moto Guzzi V7 II, KLR650 |
|
|
03-25-2016, 06:40 PM | #10 |
Join Date: Apr 2015
Posts: 366
|
worst case I can let my husband ride it during that time - he has his own bike, and I'm protective/possessive of mine, but I will share if have to LOL
|
|
03-25-2016, 07:42 PM | #11 |
Join Date: Jul 2008
Location: Idaho
Posts: 25,054
|
That is the plan I would follow.
__________________
Spud "Never argue with an idiot. He will drag you down to his level, and beat you with experience." Mark Twain 2015 Zongshen ZS250GY-3 (RX3) 2006 Zongshen ZS200GY-2 (Sierra 200) 2005 Honda XR650L 2004 Honda CRF250X 1998 Kawasaki KDX220 Mods made to my Zongshen ZS200GY-2: http://www.chinariders.net/showthread.php?t=6894 |
|
03-25-2016, 11:22 PM | #12 | |
Join Date: Jul 2015
Location: Milpitas, CA. USA
Posts: 775
|
Quote:
Don't think of it as sharing, rather that he is doing his duty as a supportive husband by caring for your treasure. |
|
|
03-26-2016, 02:04 PM | #13 |
Join Date: Apr 2015
Posts: 366
|
ha! I'm sure he won't find it a hardship
|
|
03-26-2016, 02:25 PM | #14 |
Join Date: Jul 2015
Location: Milpitas, CA. USA
Posts: 775
|
Empty tank = FeO2
I would like to point out to those that advocate draining the tank that you are then exposing the metal inside to oxygen and water condensation which can/will rust the inside. Now you are creating new problems for the fuel system.
On a carbureted engine, it's likely that a good gas filter will take care of most of the rust particles, but not all, as some are extremely small. On injected engines like ours, the pump is the first device in the stream. I don't know it's internal design, but from the sound it's an impeller and not a piston. Either way I don't think rusty bits will be good for it. Next in line is the filter, and it will remove most of the particles that get by. Of those that are small enough to get through the filter, some will return to the tank by the return line, others will go in to the injector. I try to always have a full/near full tank when I'm not going to be riding for a while. In cases where I've left the gas in too long, I've drained it and put it in the tank of my truck where it gets diluted with fresher gas, so no harm done. Keep it wet and you will be happy. |
|
03-25-2016, 07:19 PM | #15 |
Join Date: Apr 2015
Location: Sudbury ,Ontario
Posts: 855
|
I have dealt with hundreds of people who have used stabil and their carbs were a mess after storage.One of the guys was even the stabil rep who couldn't Beleive the sh1t I dug out of his carb .Just drain the fuel or go get a few cans of trufuel at Home Depot or lowes and be done with it .
|
|
|
|
|
|