Slowly losing coolant from reserve tank

RC · 07-21-2017, 01:26 PM

My reserve coolant has been inching away over the past 2000 miles. I added a little and now its creeped back down again. When doing my valve check today I found the hose clamp that attached to the top of the reserve to be a little loose, so I reattached it and hope that was the source. But I just don't see how it would lose from that. The bike hasn't been on its side at all, and if half full it can't really vibrate or slosh out.

Otherwise I have 2 suspicions- one that maybe I didn't get everything tightened up well after my 2 year coolant change a couple thousand miles ago. But I don't see any leaking. The other is a bit of a stretch, but a combination of high temperatures and high altitude might be taking a toll on the coolant? But the heat range has stayed normal as I refilled the reserve tank when it got low, so all is safe for now.

Azhule · 07-21-2017, 02:51 PM

When you changed the coolant did you burp any and all air bubbles trapped in the system?

RC · 07-21-2017, 06:09 PM

I certainly tried to per the tutorial, but don't know how successful it was. Would the fluid level still be dropping after 2k miles though?
I added a little the first ride after changing. Then the reserve went empty after 1k miles so I refilled and now it's near empty again.

BlackBike · 07-22-2017, 06:18 PM

Quote:

Originally Posted by Azhule

When you changed the coolant did you burp any and all air bubbles trapped in the system?

Az...Can the coolant get around any gaskets and contaminate the oil, or are they completely separate chambers? Increasing oil level through coolant loss?

pyoungbl · 07-22-2017, 08:49 PM

like any water cooled engine, the Zong coolant can migrate into the oil. That is most likely a head gasket issue. I'd look for coolant in the oil. An oil sample sent to Blackstone will tell if there is even a tiny amount of coolant in the oil. It is much more likely that there is a small leak at one of the hoses. I have noticed that my coolant tank seems to need a refill. The oil samples have not shown any coolant in the oil so I need to figure out where I have a leak. This confirms the sweet smell I got from the engine on my last long ride. It's just a matter of figuring out where I have the leak. It must be really tiny!

Peter Y.

rd1959 · 07-23-2017, 07:45 AM

Have you checked the radiators for leaks along any of the seams? I had a car once that would lose coolant but only when it was completely warmed up. It took me a while until I discovered a seam that was leaking when hot but it would close up after the rad cooled down. It never left any evidence on the ground or any telltale marks, it was just losing coolant. I guess the radiator leak gremlin was tired of messing with me so he finally allowed me to see where it was leaking.

Citroenjunkie · 07-23-2017, 04:40 PM

When I bought my bike the expansion tank needed a top up, just over 2000 km later it was the same, a top up of about 1/2 a cup of coolant.

Everything else is spot on, there has been no signs of the engine running hot or any signs of water in the oil which is still a transparent golden colour.

I've decided to keep an eye on it and not stress, probably not scientific but I can't see anything broken so I'm not fixing it.

Quote:

Originally Posted by RC

I certainly tried to per the tutorial, but don't know how successful it was. Would the fluid level still be dropping after 2k miles though?
I added a little the first ride after changing. Then the reserve went empty after 1k miles so I refilled and now it's near empty again.

RC · 07-24-2017, 05:22 AM

Its a little too soon to know for sure, but I think tightening the hose/clamp at the top of the reserve has stopped it. I didn't think that would be the cause because I can't see any signs of leakage from there, and I don't think there is enough air exposure to evaporate it, at least not at that pace. Will update in a week or so.

willy dog · 07-24-2017, 09:02 AM

i have topped my tank off three or four times seems to have stabilized now

2LZ · 07-24-2017, 04:11 PM

The clamps on these are horrible. I've had a couple small weeps after just moving a couple clamp heads around the hose a little to aid access to other things and couldn't get them to quit oozing, once I cracked that seal. I have changed the clamps to a better quality clamp every time this has happened but as others have said here, it takes a while to get it to stabilize.

RC · 09-28-2017, 09:46 AM

Agreed, those clamps are a PITA! It took about 30 tries of grabbing and tugging with a pair of pliers, but I finally got it to seat perfectly. And 3000 miles later the fluid level hasn't changed.

07-21-2017, 01:26 PM	#1
RC Join Date: Apr 2017 Location: EurAsia Posts: 46	Slowly losing coolant from reserve tank My reserve coolant has been inching away over the past 2000 miles. I added a little and now its creeped back down again. When doing my valve check today I found the hose clamp that attached to the top of the reserve to be a little loose, so I reattached it and hope that was the source. But I just don't see how it would lose from that. The bike hasn't been on its side at all, and if half full it can't really vibrate or slosh out. Otherwise I have 2 suspicions- one that maybe I didn't get everything tightened up well after my 2 year coolant change a couple thousand miles ago. But I don't see any leaking. The other is a bit of a stretch, but a combination of high temperatures and high altitude might be taking a toll on the coolant? But the heat range has stayed normal as I refilled the reserve tank when it got low, so all is safe for now.
	0

07-21-2017, 02:51 PM	#2
Azhule Join Date: Dec 2015 Location: CO Posts: 1,525	When you changed the coolant did you burp any and all air bubbles trapped in the system? __________________ "Think as you like... but this self proclaimed Professor is always right" - Buckshot "You never know what someone is hiding beneath their smile..." - NinjaTom - R.I.P.
	0

07-24-2017, 09:02 AM	#9
willy dog Join Date: Oct 2015 Location: vermont Posts: 238	i have topped my tank off three or four times seems to have stabilized now __________________ Peace and Zong Life
	1

07-24-2017, 04:11 PM	#10
2LZ Join Date: Mar 2010 Location: Volcano, Ca Posts: 7,112	The clamps on these are horrible. I've had a couple small weeps after just moving a couple clamp heads around the hose a little to aid access to other things and couldn't get them to quit oozing, once I cracked that seal. I have changed the clamps to a better quality clamp every time this has happened but as others have said here, it takes a while to get it to stabilize. __________________ "Light a fire for a man, and you heat him for a day. Light a man on fire, and you heat him for the rest of his life." 2007 Suzuki DRZ400S (SM convert) 2009 Q Link XP 200 1967 BSA B25 250cc Starfire 2022 Royal Enfield Interceptor 650 2023 Royal Enfield Scram 411 1948 Royal Enfield Model G 350
	1

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-21-2017, 06:09 PM	#3
RC Join Date: Apr 2017 Location: EurAsia Posts: 46	I certainly tried to per the tutorial, but don't know how successful it was. Would the fluid level still be dropping after 2k miles though? I added a little the first ride after changing. Then the reserve went empty after 1k miles so I refilled and now it's near empty again.
	0

07-22-2017, 08:49 PM	#5
pyoungbl Join Date: Feb 2016 Location: Portsmouth, Virginia, USA Posts: 632	like any water cooled engine, the Zong coolant can migrate into the oil. That is most likely a head gasket issue. I'd look for coolant in the oil. An oil sample sent to Blackstone will tell if there is even a tiny amount of coolant in the oil. It is much more likely that there is a small leak at one of the hoses. I have noticed that my coolant tank seems to need a refill. The oil samples have not shown any coolant in the oil so I need to figure out where I have a leak. This confirms the sweet smell I got from the engine on my last long ride. It's just a matter of figuring out where I have the leak. It must be really tiny! Peter Y.
	1

07-23-2017, 07:45 AM	#6
rd1959 Join Date: Jul 2017 Location: Monroe,NC Posts: 131	Have you checked the radiators for leaks along any of the seams? I had a car once that would lose coolant but only when it was completely warmed up. It took me a while until I discovered a seam that was leaking when hot but it would close up after the rad cooled down. It never left any evidence on the ground or any telltale marks, it was just losing coolant. I guess the radiator leak gremlin was tired of messing with me so he finally allowed me to see where it was leaking.
	0

07-24-2017, 05:22 AM	#8
RC Join Date: Apr 2017 Location: EurAsia Posts: 46	Its a little too soon to know for sure, but I think tightening the hose/clamp at the top of the reserve has stopped it. I didn't think that would be the cause because I can't see any signs of leakage from there, and I don't think there is enough air exposure to evaporate it, at least not at that pace. Will update in a week or so.
	0

09-28-2017, 09:46 AM	#11
RC Join Date: Apr 2017 Location: EurAsia Posts: 46	Agreed, those clamps are a PITA! It took about 30 tries of grabbing and tugging with a pair of pliers, but I finally got it to seat perfectly. And 3000 miles later the fluid level hasn't changed.
	0