2.0 generation of the centerstand.
The top ends were pre-ground.
After reading the CSC tutorial, the installation took about 10 minutes.
I was a concerned about lifting the bike onto the stand because I also have the lowering link installed.
And because of some health issues, I have lost a lot of the strength I once had.
On the first attempt, I couldn't do it.
Then rolled a 3/4" board under the rear wheel, and gave a grunt...
On the second attempt, besides adding the board under the rear wheel,
I altered my holding and lifting technique. The bike popped up on the stand.
I had to keep an eye on the front handlebars. They kept wanting to flop to the side.
A few concerns:
....ground clearance...
.....and for off road riders, maybe a way to snag a branch or rock???
....make sure the kick stand is down before taking the bike off the center stand.
....and maybe a
warning for those working around the bike when it is on the center stand...
...it only took a
slight nudge for the bike to roll forward off the stand.
jb