Dante' says
 

You know there is a special place in hell for people like that.

Hi Everyone, Greetings from Colombia, sorry for my bad English, I would like to ask, what are the dimensions of the shock of the RX3, I'm thinking of modifying the suspension of this bike, I appreciate your response. Thank you.

I just ordered a front sprocket for a 90-98 DR350, I'll let you know if it works when it gets here.

I finally got around to installing the 1995 DR350 Front Sprocket on my RX3, fit perfect, only difference is there is no hole for the "keeper" to lock into, I installed it with some locktite, hopefully it'll hold.
I didn't think I have a drill bit that would drill thru the hardened steel of the sprocket.

I live in China and could buy n sell etc
Be a cool little sideline to what I do bike wise etc.

Hi,

A fellow confirmed that Yamaha clutch disks part# 5Y1-16331-01 are a perfect match to our RX3

Regards,

Juanro

Back Sprocket
 

Hi all

I bought back brake pads for my 2015 RX3 from the local Honda dealer, they're from one of their offroad bikes, Nissin I think.

What I wanted to ask was which back sprockets have the same Pitch circle diameter and bolt centers?

I'd like to experiment with smaller rear sprockets to see how high I can gear the bike up.

My bike will rev right up to redline in top and feels like it would keep accelerating if I let it, so my plan is higher gearing. Although we're about 35 km inland we're still pretty much at sea level and as long as I don't start packing on the pork the engine seems strong enough.

Anyone tried altering the back sprocket?

I seem to recall an old post by Spudrider that said that the JTR811 was compatible. He used a 46 tooth version, but there are other sizes:
http://www.jtsprockets.com/catalogue/sprocket/JTR811/
I don't know how hard to get those are or if anyone can verify this information, though.

sprocket
 

Thanks Mr Google says this is a standard Suzuki on/off road bike sprocket. We have a Suzuki shop in town:clap:
:thanks:

What front sprocket do you have 13T 14T 15T?

RX3 stuff is pretty easy to get etc.

The RX3 rear sprocket has an odd bolt pattern diameter. I remember trying to install a rear sprocket from one of the Japanese bikes "it's supposed to fit" only to find that the bolt holes were off by about 1-2mm. Spud discovered this too and had to drill out the rear sprocket holes. CSC sells a variety of rear sprockets that will fit and they are not horribly expensive.

Peter Y.

Control levers
 

After an unfortunate "dropped bike" I have discovered that the control levers, specifically the front brake, is an exact swap with a Suzuki GN125. Great news as this bike is sold worldwide (Well New Zealand wide anyway) Total cost of a set of new levers NZ$ 16.99 + 5.00 postage.

Another discovery the mirrors have a 10mm thread. Anyone need a set of mirrors with and 8mm thread?

lookit what i found?

https://www.aliexpress.com/item/4000...archweb201603_

That won’t work with stock RX3/3S/4
Very different and has tire pressure mon etc
On RX4 needs full new loom etc
These are common high grade version in china like the wheels or DOHC RX3 engine etc
USA version is kinda more basic