humanbeing

Hi there Humanbeing, this is Torker, from Ft. Worth Texas. I was given your info by a member of the forum. Can you, maybe, help me find a stator for my Pentora 250 ATV?
This is the thread: https://www.chinariders.net/showthread.php?t=31123
I'm having a really hard time finding this particular stator. Please, let me know if you can help me. Nice meeting you.

TORKER.

I started a post last week looking for help identifying the motor on my Apollo Sportrax 125cc atv in the atv forum and was directed to you. I can’t find anything on the internet as who manufactures the engine as it has an oil leak at the stator cover. The plate on the engine shows 152FMI and below it between two stars is 17048675. It’s also automatic with reverse. Any ideas? Thank you for the help!

Hello Humanbeing! I have the searched the forums and can't seem to find an answer, but thought you would know. I'm wondering if I would be able to install a new 67mm (CG250) cylinder and piston in my Lifan 197cc (CG200) motor.. You are an expert on these bikes. By the way, your advise on a new stator helped me out alot- I was able to get way more power from the 18 pole stator. Thank you!!!

hey do you know where i can get a clutch cover gasket and air fliter cover for a 2004 flywing mx 150

also being new I don't know how to tell if you answer me so can you post something telling me to check back here. Any good parts suppliers in Texas? I called VMC and the girl said they only go by pictures (wht ever that means) and they didn't have anybody I could speak to for guidance on the right parts.
Thanks again.

Hello human being,
I'm new here and I was told your the best on Taotao. I know you saw my post about my starter noise issue. I'm thinking of just replacing the starter and all the gears all the way to the starter drive clutch but I can figure out which starter drive clutch is the correct one can you help me out. I have a list of part numbers off VMC. i'm at my wits end trying to figure this issue out. Like I've said it sounds almost like it's trying to backfire through the carb. Any help would be so helpful.
Thanks again.

Appreciate the info, Thanks. John

HB, do you know where I can buy a front motor mount for my j2005 Jailing GY200 that would have room for the counter balance shaft in front of motor? My old motor was a JL163FML that did not have a counter balance shaft so the old motor mount doesn't fit. The new motor mounting bolt holes are farther apart with the lowest bolt hole in motor being the different one from original motor. top 3 mount holes are in same place as original, just lowest hole on bottom of motor is maybe 1/2" farther down.
Also the new motor's mounting hole casting is wider from center of engine case to the RH clutch side of motor . I think the RH side of the motor mounts on alternator side are same as old motor. Thanks, Rj in Walla Walla, usa

I hear that you're the taobao and aliexpress expert. Do you happen to know if there are any 21" front wheels on there that are a direct fit for the Hawk? I looked, but no idea what I'm looking for.

You were recommended to me. I was trying to find out what gas cap will fit my 2006 Roketa db-06 200cc dual sport made by Shineray. It has a metal tank and gas cap goes directly down and locks. No turning of the cap itself. Thanks. Lance