Hey Spud. ..took my rear shock linkage off to regrease it. Also removed the swingarm. The brake side was very dry. Anyhow. .for the torque spec sticky, you can add the swingarm torque spec per Gerry at csc is 54 ft lbs. I appreciated your how to on this!

Read post #2 in the following thread for connector information.

http://www.chinariders.net/showthread.php?t=15437

You are correct. However, I would not clip the wires on the auxiliary harness. I installed the appropriate connector. Also the green wire of the harness is the ground wire, and the other wire, I believe it is pink, is the hot wire.

I had a question re: LED aux lights as it looks like you and I have the same ones. To install them to the handlebar A1/A2 switch, from the lights, I would tie both negative leads together, join both positive leads, run the 2 wires (pos and neg) to one of the leads noted in the tutorial, clip the plastic plug off, see which one is hot with a continuity tester, and splice them together. Am I correct in all this? Thanks a million!