2022 1/2 Templar X

Thumper · 08-30-2022, 07:05 PM

I pulled the carb and there are just TWO break-off bolts holding the float bowl in place.

I used a fine saw this time to cut a flathead slot. STILL barely got the first one off. I actually used an impact driver. Shocked at how hard to remove!
Name: 1stScrew.JPG
Views: 1010
Size: 148.4 KB

Name: 1stScrew.JPG
Views: 1010
Size: 148.4 KB

The second one was NOT as cooperative, so I ground off the head and removed the bowl. To my surprise, the shaft of the bolt was EASILY accessible. I could have just ground off the head on BOTH of them. Once exposed, it was no match for a vice grip.

Name: pinchShaft.JPG
Views: 986
Size: 164.4 KB

Name: pinchShaft.JPG
Views: 986
Size: 164.4 KB

But the reason became obvious. They are loctite sealing these in place!
HAH!!! No match for a dremel and vice grip!

Name: loctite.JPG
Views: 971
Size: 152.2 KB

Name: loctite.JPG
Views: 971
Size: 152.2 KB

BY THE WAY... Threads are M4 -.7
I got a couple of 16mm Allen bolts to replace them.

08-30-2022, 07:05 PM	#7
Thumper Join Date: Feb 2021 Location: Kansas City Posts: 2,292	Smoothbore Carburetor I pulled the carb and there are just TWO break-off bolts holding the float bowl in place. I used a fine saw this time to cut a flathead slot. STILL barely got the first one off. I actually used an impact driver. Shocked at how hard to remove! The second one was NOT as cooperative, so I ground off the head and removed the bowl. To my surprise, the shaft of the bolt was EASILY accessible. I could have just ground off the head on BOTH of them. Once exposed, it was no match for a vice grip. But the reason became obvious. They are loctite sealing these in place! HAH!!! No match for a dremel and vice grip! BY THE WAY... Threads are M4 -.7 I got a couple of 16mm Allen bolts to replace them. Last edited by Thumper; 08-31-2022 at 01:26 PM.
	4