10-21-2015, 07:17 PM
|
#1 |
Join Date: Jul 2015
Location: Tigbauan, Iloilo City, Panay Island, Philippines
Posts: 177
|
My bars risers
Couldn't find a thread if there is one on bar risers so figured I'd do this. and share my bar risers. Had two sets made up, one is 3/4" high and one is 1" high. I wanted 1" but at the time I didn't know if there would be enough slack in the wiring harness but there was plenty of slack and so I am use the 1". Stainless steel.
__________________
Riceburner Robin / Face Hunter I Medical Mission Matters www.medicalmissionmatters.org |
|
|
10-22-2015, 12:41 AM
|
#3 |
Join Date: Jul 2008
Location: Idaho
Posts: 25,054
|
You are keeping Juan, the machinist, very busy, amigo.
__________________
Spud "Never argue with an idiot. He will drag you down to his level, and beat you with experience."  Mark Twain2015 Zongshen ZS250GY-3 (RX3) 2006 Zongshen ZS200GY-2 (Sierra 200) 2005 Honda XR650L 2004 Honda CRF250X 1998 Kawasaki KDX220 Mods made to my Zongshen ZS200GY-2: http://www.chinariders.net/showthread.php?t=6894 |
|
|
|
|
|
 |
|
|
Linear Mode
