Apollo Commander 200 Brake Caliper / Parts

dirtbkr188 · 02-12-2021, 09:20 AM

Sorry, I should have been more specific, I meant the threaded mounting holes for the caliper where it bolts to the axle carrier, and then compare with the ones VMC lists.

Did you compress the puck back into the caliper fully, to give the brake pads room to fit over the rotor?

**JerryHawk250** · 02-12-2021, 09:47 AM

I've been through this already. I had to swap the mounting bracket from the old one to the new one.

Tahoe2x · 02-12-2021, 10:28 AM

Quote:

Originally Posted by JerryHawk250

I've been through this already. I had to swap the mounting bracket from the old one to the new one.

JerryHawk250, Do you know where / PN that you ordered? If all that would need to do is swap brackets that would be great.

What did you order yours for?

Thanks in advance.

**JerryHawk250** · 02-12-2021, 01:05 PM

Quote:

Originally Posted by Tahoe2x

JerryHawk250, Do you know where / PN that you ordered? If all that would need to do is swap brackets that would be great.

What did you order yours for?

Thanks in advance.

My caliper was different than yours. I found a caliper that match what I had and swapped the brackets. This was on a Cazador 180 UTV.

Tahoe2x · 02-12-2021, 10:25 AM

Quote:

Originally Posted by dirtbkr188

Sorry, I should have been more specific, I meant the threaded mounting holes for the caliper where it bolts to the axle carrier, and then compare with the ones VMC lists.

Did you compress the puck back into the caliper fully, to give the brake pads room to fit over the rotor?

The center mounting holes are 2.5 in. So I ordered the - Rear Disc Brake Caliper - Version 4. That has the same measurements. But - That is more like for the smaller front rotors that are 5.11 inches. The rear rotor is 8.66 inches.
I tried with the puck fully compressed in, and also tried to line up without pads installed.

The calipers old/new were too different to even swap parts / brackets / pads to make something work.

02-12-2021, 09:47 AM	#2
JerryHawk250 Moderator Join Date: Oct 2016 Location: Houma, La. Posts: 11,555	I've been through this already. I had to swap the mounting bracket from the old one to the new one. __________________ 2023 Lifan Lycan 250 Chopper 2023 Venom Evader 2022 Lifan KPX250 2020 Kawasaki Vulcan S 2004 Honda ST 1300 2016 Black Hawk 250 (sold) Keihin PE30 carb,125 main,38 slow.Pod filter,ported & decked head 10:1 CR,Direct Ignition Coil,15/40Sprockets,NGK DPR8EIX-9,De-Cat,Dual Oil Cooler,Digital Cluster 2016 Cazador180 XL 2014 Coolster150 JerryHawk250.com My YouTube Channel
	0

02-12-2021, 09:20 AM	#1
dirtbkr188 Join Date: Aug 2009 Posts: 503	Sorry, I should have been more specific, I meant the threaded mounting holes for the caliper where it bolts to the axle carrier, and then compare with the ones VMC lists. Did you compress the puck back into the caliper fully, to give the brake pads room to fit over the rotor?
	1