RX3: Engine Top End Rebuild at 22,450 Miles - Page 6

artur94 · 04-14-2024, 05:32 AM

Hi all I have a question about the Rocker arms Pins orientation. I had to do service of top end of my bike engine as one of the baring has fail on the camshaft, lucky, I have stop using the bike immediately when start hearing some ode noises in the engine. I did replace the rocker arms with pins but now I am not sure if I have installed the pins correctly… Where should be the flat spot of Pins orientated – UP towards petrol tank or Down towards ground? Thanks for Help

04-14-2024, 05:32 AM	#76
artur94 Join Date: Jul 2015 Posts: 35	Hi all I have a question about the Rocker arms Pins orientation. I had to do service of top end of my bike engine as one of the baring has fail on the camshaft, lucky, I have stop using the bike immediately when start hearing some ode noises in the engine. I did replace the rocker arms with pins but now I am not sure if I have installed the pins correctly… Where should be the flat spot of Pins orientated – UP towards petrol tank or Down towards ground? Thanks for Help
	0