Adjusting your brake pedal height

[detours]

Adjusting the brake pedal height wasn't obvious to me, but it turned out to be pretty simple. (Maybe I should have read the manual )

1. Follow the brake pedal back to the rubber boot under the rear brake reservoir.
2. Carefully pull the rubber boot up from the bottom to expose the lock nut.
3. Using a 10mm open-ended wrench, loosen the lock nut. Leave plenty of room.
4. Grasping the rubber boot, turn the entire bolt by hand. It will move easily and adjust the brake pedal up or down.
5. At the desired height, tighten the locknut
6. Carefully pull the boot down over the locknut. Make sure the top of the boot stays in its groove and maintains a good seal.