Go Back   ChinaRiders Forums > Technical/Performance > Dual Sport/Enduro
Register FAQ Community Calendar Today's Posts Search
Reply
 
Thread Tools Search this Thread Display Modes
Old 05-06-2024, 09:54 PM   #1
MN-Chonda   MN-Chonda is offline
 
Join Date: Jul 2021
Location: MN
Posts: 12
Doh! TBR7 Venting Oil from Crankcase after oil change

I am the second owner of a 19 TBR7. I have modified the bike with aftermarket carb, removed the air box and added cone foam filter, after market exhaust,
Sprocket change and new chain. After I removed the air box, I added the crankcase vent with a pcv valve and crankcase filter on the end routed to the top of the underside of the seat on the exhaust side.

I finally changed the oil to the recommended Rotella 15w-40 at 1,600 miles. Previous owner did change out the shipping oil for 10w-30 when new. I bought the bike with 300 miles on it.

I measured and added 1.1L and final oil level after the engine was started was just below the high level mark on the dipstick.

My issue is that it's venting a lot of oil and I believe the cause to be the change in oil viscosity and that I added too much oil since it was just before the high mark.

Has anybody else experienced this with their bike when using Rotella?
Would it be better to just route this over the chain with a solid elbow to lubricate the chain instead of using a filter at the end?


 
Reply With Quote
Old Yesterday, 12:49 AM   #2
Megadan   Megadan is offline
 
Megadan's Avatar
 
Join Date: Apr 2017
Location: Omaha, NE
Posts: 7,972
You didn't add too much, technically. The crankcase ventilation system just lacks any sort of valve or other form of separator to help block the oil that finds its way to the vent tube. Then, the vent tube itself is mostly horizontal, so oil doesn't effectively drain back.

Most people try to solve this by adding just 1 quart of oil, which usually puts the oil around the half to 2/3 way up mark. It is effective and definitely helps, but it is still just a band aid work around.
__________________
Hawk Information and Resource guide: http://www.chinariders.net/showthread.php?t=20331
2018 Hawk 250 - Full Mod list here. http://www.chinariders.net/showpost....62&postcount=1
2024 Royal Enfield Shotgun 650
https://chinariders.net/showthread.php?t=34124


 
Reply With Quote
Old Yesterday, 10:26 PM   #3
buzz   buzz is offline
 
Join Date: Dec 2020
Location: Dayton Pa.
Posts: 857
no way i'll bet your motor is shot,blowby my friend. 300 miles or not ,why did 1st seller sell???


 
Reply With Quote
Old Today, 01:01 AM   #4
Captcj68chris@aol.   Captcj68chris@aol. is offline
 
Join Date: Mar 2020
Location: Bowling greenK.Y. elev. <1000 ft
Posts: 93
Hi MN chonda. Reduce the level of the oil in the crank case. Should be 1 quart only. Any more will increase the possibility of blow by into the air box via the vent tube from the crank case. A little is ok
They all do. That's why there is a drain plug at the bottom. Common issue with these motors.
Just make sure the dipstick/ sight glass reads ok. You'll be fine.


 
Reply With Quote
Old Today, 01:06 AM   #5
Captcj68chris@aol.   Captcj68chris@aol. is offline
 
Join Date: Mar 2020
Location: Bowling greenK.Y. elev. <1000 ft
Posts: 93
RE:: the air box has a drain plug at the bottom. Little rubber cap. For draining. Anything more then a little film at the bottom is acceptable. Your motorcycle is fine


 
Reply With Quote
Old Today, 02:58 AM   #6
Megadan   Megadan is offline
 
Megadan's Avatar
 
Join Date: Apr 2017
Location: Omaha, NE
Posts: 7,972
Quote:
Originally Posted by buzz View Post
no way i'll bet your motor is shot,blowby my friend. 300 miles or not ,why did 1st seller sell???
Huh? This is a well documented thing with the Hawks and Hawk like bikes.
__________________
Hawk Information and Resource guide: http://www.chinariders.net/showthread.php?t=20331
2018 Hawk 250 - Full Mod list here. http://www.chinariders.net/showpost....62&postcount=1
2024 Royal Enfield Shotgun 650
https://chinariders.net/showthread.php?t=34124


 
Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:13 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.