Hawk 250 parts

[NzBrakelathes]

Originally Posted by JerryHawk250

There is no gasket. Air box doesn't seal up well and dust will get sucked in. That's why I switched to a pod filter.

The top lid? doesn't need a gasket as filter is the seal

[NzBrakelathes]

Originally Posted by nij_tp

Hi, hope you are ok. This is probably really stupid but do you have the rubber gasket that goes round the air box, I took the top off to modify and there is no gasket! (brand new bike with 0.4 miles on it!!) Shipping 03031

Thanks

Look again at the lid - why have a gasket?
the filter it self is the seal etc

[JerryHawk250]

Originally Posted by NzBrakelathes

The top lid? doesn't need a gasket as filter is the seal

The bottom portion is in two pieces too. Dust gets sucked right through. I probably could of put silicon to seal it off.

[Megadan]

Originally Posted by NzBrakelathes

Look again at the lid - why have a gasket?
the filter it self is the seal etc

Except the filter seals to a section that bolts to another lower section, and that is not sealed.

[NzBrakelathes]

This part? Lid has no seal
Or are you asking for next later down?
I have an air box without a hose if parts from it help etc

[nij_tp]

Originally Posted by JerryHawk250

There is no gasket. Air box doesn't seal up well and dust will get sucked in. That's why I switched to a pod filter.

Oh ok, I thought there was a channel that looked like it housed a rubber seal.

[krawl]

My air filter lid came with a rubber gasket, it is just a round rubber strip cut to length and partially fell out as I took the lid off. I had to stretch it as I placed it back into the slot around the outer edge of the lid to make the ends meet.