2016 Hawk 250 Rear Fender

[NotTheRealMVP]

Alright Chinariders, I turn to you again for help.
I recently bought my 2016 Hawk and over the passed week or so I've been fixing up everything to make it pass inspection, however, I've got one outstanding problem remaining.

The owner before me didn't like the fender, understandably, but instead of taking the time to remove it the correct way, and decided to use a hack saw.

So I've got the working rear light, and all the wiring, however the original wire to the license plate light was cut (3/4 of it remains), but that's not a big deal.

I need help finding the correct fender, with license plate mount, and the license plate light, (which I assume will come with the wire attached) to hopefully complete my task of making the bike street legal.

The only success I've found is http://therps.net/DB-Hawk.html (Go to parts then plastics then scroll to the bottom).

However if you find any better parts/places to get them, it would be greatly appreciated.

Update: Found what seems to be all the parts for the TT250 on CSC, and they look like the should fit, just looking to confirm.

[pcspecialist]

I can't vouch for the parts you wish to replace, but, I've used quite a few TT250 parts on my Hawk. I seem to recall someone else replacing the same parts as you need to and went with TT250 parts.

[pcspecialist]

Don't get the license plate bracket though, most of us throw that out and mount the plate directly to the fender. I don't have any photos taken to show how I mounted my plate, but, in #46 you can see how nicely it fits without the bracket:

http://www.chinariders.net/showthrea...t=16636&page=4

[Megadan]

I ordered a side panel through TXPOWERSPORTS parts ordering. Their prices are a little ridiculous, but it will be a Hawk specific part.
Main parts page https://www.txpowersports.com/category_s/314.htm

Rear fender. https://www.txpowersports.com/ricky_....100044.01.htm

Rear plate light: https://www.txpowersports.com/ricky_....100044.03.htm

Another option would be to try a TT250 rear fender, the price is half that of the genuine hawk parts, and the TT250 is a very similar bike so it is likely to work, but since I have no direct knowledge it will actually work it would be a slight gamble. However, considering many of the body panels, and the seat, will directly fit on a Hawk, the chances are good that it will mount up. My Hawk already has a number of TT250 parts on it that I bought simply because the prices were WAY cheaper than the Hawks parts.
http://www.cscmotorcycles.com/TT250-...NDER-s/338.htm

[silva]

I installed this on my hawk. http://www.cscmotorcycles.com/TT250-...p/zt12-101.htm http://www.cscmotorcycles.com/TT250-...p/zt35-100.htm ----------------------------------------------------------------------- http://www.cscmotorcycles.com/TT250-...p/zt35-101.htm

[Megadan]

^There you go. That's the evidence I was missing. Thank you Silva!

[pcspecialist]

I used TT250 side panels on my Hawk (see #66) to give you an idea just how compatible many TT250 parts are with the Hawk.

http://www.chinariders.net/showthrea...t=16636&page=5