03-07-2024, 10:59 PM | #1 |
Join Date: Aug 2022
Location: Lincoln CA
Posts: 120
|
TT250 rear axle adjuster plates
Has anyone found any pre-made billet aluminum rear axle adjuster plates that fit the stock CSC TT250 swingarm? The stock stamped steel plates are some of the more glaring of the cheesy-China items on this bike that I'd like to upgrade. I've searched high and low on amazon, ebay, aliexpress, temu, etc. and found a few that are close, but no cigar. They typically only give the outside dimensions (if they give dimensions at all) and all that I've found that are close are off on the long length by being too long. I suppose I could buy a set and then mill them down to fit but if I'm going to go to that trouble I may as well just mill a set from billet myself. Not that I'm opposed to doing that, it's just that a pre-made set for $10-$20 off of one of these sites would be preferable just to avoid the hassle. For what it's worth, the outside measurements on the back of the rectangular box section swingarm on the 2024 CSC TT250 are 30mm x 50mm, if that helps.
Thanks in advance if anyone has a lead on any they've found that work. The attached images are of the closest ones I've found. Last edited by superjocko; 03-08-2024 at 06:16 PM. Reason: typo |
|
|
|
|
|