'20 RXB250L - NC250 Motor Swap [Build Thread]

Ursa_Adv · 09-29-2022, 07:48 PM

Nibbi carb is in. I lucked out and it came with a 32 pilot installed. Small victories. Clutch cable and throttle cable have been adjusted with proper slack.

I need to pick up a 55mm hose clamp for the intake (the largest I have is a 52mm). With that everything is locked in place and I can start putting more of the bike back together.

I also managed to find a better spot to mount the coil as well.

Things to complete:

Fill radiator
Fill engine with oil
Put new master link on chain
Set chain tension
Grease front axle
Torque front axle
Drain and refill gas tank
Remount front brake
Refill and bleed front brake
Exhaust

*NOTE: please don't judge me too harshly for those terribly cut coolant lines. I didn't swap out razor blades until it was far too late.

09-29-2022, 07:48 PM	#11
Ursa_Adv Join Date: Jan 2021 Location: PNW Posts: 116	Nibbi carb is in. I lucked out and it came with a 32 pilot installed. Small victories. Clutch cable and throttle cable have been adjusted with proper slack. I need to pick up a 55mm hose clamp for the intake (the largest I have is a 52mm). With that everything is locked in place and I can start putting more of the bike back together. I also managed to find a better spot to mount the coil as well. Things to complete: Fill radiator Fill engine with oil Put new master link on chain Set chain tension Grease front axle Torque front axle Drain and refill gas tank Remount front brake Refill and bleed front brake Exhaust NOTE: please don't judge me too harshly for those terribly* cut coolant lines. I didn't swap out razor blades until it was far too late. __________________ NC250 Swapped '20 Orion RXB250L Build Thread
	1