2nd Generation, CSC Center Stand: Installation

Chucho · 02-07-2017, 02:20 AM

Hi Guys! I am new to this forum, and this is actually my first post. Sorry if I am breaking protocol with this message as I still have a lot to learn about forum rules.

The issue I found with the installation of the Gen 2 center stand is that the mounting points under the frame of my RX3 are wider than the distance between the two grooves on the pivot shaft. I can install one circlip at one end of the shaft but the second groove on the opposite end is not even visible when the shaft is fully inserted.

Is it ok/recommended to grind the mounting points?

Thanks!

Chucho

02-07-2017, 02:20 AM	#24
Chucho Join Date: Jan 2017 Location: Chula Vista, CA Posts: 8	Hi Guys! I am new to this forum, and this is actually my first post. Sorry if I am breaking protocol with this message as I still have a lot to learn about forum rules. The issue I found with the installation of the Gen 2 center stand is that the mounting points under the frame of my RX3 are wider than the distance between the two grooves on the pivot shaft. I can install one circlip at one end of the shaft but the second groove on the opposite end is not even visible when the shaft is fully inserted. Is it ok/recommended to grind the mounting points? Thanks! Chucho
	0