110 break in procedure...

Kelly W · 10-09-2014, 03:13 PM

Hi everyone, new to the forum...

I have 2 generic 110 Chinese quads, one virtually brand new but 2nd hand, and one that's very well used.

New 110

Old 110

Both are semi auto with reverse. The new one is a chain drive rear end, and the older one is a shaft drive.

I'm going to change the default supplied oil in the new ATV this weekend and take it out for a first gentile ride. Unfortunately neither quad had any kind of an instruction manual though, so I'm looking for some guidance on the break in procedure, what oil I should use for the 1st few changes, etc.

I'd appreciate any comments / suggestions.

Thanks,
Kelly W

10-09-2014, 03:13 PM	#1
Kelly W Join Date: Oct 2014 Location: Delta, BC (near Vancouver) Posts: 8	110 break in procedure... Hi everyone, new to the forum... I have 2 generic 110 Chinese quads, one virtually brand new but 2nd hand, and one that's very well used. New 110 Old 110 Both are semi auto with reverse. The new one is a chain drive rear end, and the older one is a shaft drive. I'm going to change the default supplied oil in the new ATV this weekend and take it out for a first gentile ride. Unfortunately neither quad had any kind of an instruction manual though, so I'm looking for some guidance on the break in procedure, what oil I should use for the 1st few changes, etc. I'd appreciate any comments / suggestions. Thanks, Kelly W
	0