04-11-2019, 10:01 PM | #2 |
Join Date: Jun 2018
Location: Florida
Posts: 759
|
That's a sweet pipe there man, i like that carbon fiber look canister on it, I'll add it to the sites list of parts confirmed to fit Vaders and the source !
__________________
2001 Mustang GT 2004 Sportster 2018 VADER 2020 Orion RXB250L |
|
04-11-2019, 10:17 PM | #3 |
Join Date: Apr 2019
Location: Pennsylvania
Posts: 32
|
it will look nice on my black bike!
|
|
04-12-2019, 07:05 AM | #4 |
Join Date: Apr 2019
Posts: 6
|
Have you fitted to your Vader yet?? That's the same pipe I bought for My hellcat and know way did it fit the head pipe is bent way wrong had to heat the crap out of it to bend it into position just saying
|
|
04-12-2019, 09:29 AM | #5 |
Join Date: Feb 2018
Location: nashville
Posts: 574
|
]interesting. i would love to know if this fits. i doubt it will fit without bending that first turn off the engine exhaust flange...the thickness/length of the exhaust pipe flange looks long enough, but the angle appears off at the first bend in the pipe....
here is paste of my older thread. "been there done that" i purchased low mount exhaust for grom: https://www.ebay.com/itm/SC-Low-Moun...72.m2749.l2649 * it did not fit in two ways: 1) the Spigot-collar is too short 2) it seems as if it angles off a honda grom engine directly down. my 125cc lifan on the venom x20 has a slight angle toward the rear. other words....a 90 degree bend off engine is grom, and the x20 needs maybe 100 degree bend. not sure if its a difference of engine being mounted differently or the exhaust hole on engine is in fact at a different angle from grom to x20. * i have read where a pipe adapter fixes a common problem with klx to honda with: http://shop.pitsterpro.com/nccpipeadapter.aspx or maybe stacking some 2-3 Crushable exhaust gaskets: http://tboltusa.com/store/tech.php?p...+Pipe+Adapters all said if i can change the depth of my collar and change the angle, my purchased exhaust would fit. Attachment 16520 Attachment 16521 Attachment 16522 Last edited by imapdog; 02-14-2020 at 08:48 AM. |
|
04-12-2019, 12:27 PM | #6 |
Join Date: Apr 2019
Posts: 6
|
Well here is my experience you have to heat the pipe need a oxy act torch to get it hot enough to bend it be careful it's ss and it can split you'll need a big pipe shoved into the exhaust to bend little steps at a time. And yes 2 copper crush washers will work. The mount for muffler ends up where the rear foot peg is you'll have to remove it and drill a hole for a nut and bolt for the muffler mount good luck
|
|
|
|
|
|