04-10-2024, 03:02 PM | #1 |
Join Date: May 2023
Posts: 17
|
Trying to figure out my new carburetor
I bought from Amazon a 32mm carb for my 200cc Zongshen engine. I've got most of it figured out, but one question lingers. In the first picture you see a hose from the bottom of the float bowl to the opposite side of the carb near the throttle. (Ignore the extra length as I don't want to cut things until I'm sure where they go.) In the second picture you see a nipple just like in the first picture but on the opposite side. I haven't been able to discover its purpose. Should it be connected to something, covered or just left as is?
|
|
04-10-2024, 03:11 PM | #2 |
Join Date: Feb 2024
Location: SW Missouri
Posts: 192
|
The one in the second pic is where you connect the line to the fuel tank
__________________
---------- 2023 Templar X 2009 Triumph Bonneville 1976 Yamaha DT175 1974 Honda MT125 |
|
04-10-2024, 03:45 PM | #4 |
Join Date: Feb 2024
Location: SW Missouri
Posts: 192
|
Got it. Looking online I believe there's two overflow connections. One currently has the fuel bowl drain connected to it and the other is the one you circled.
https://www.mopedarmy.com/forums/read.php?1,4543258
__________________
---------- 2023 Templar X 2009 Triumph Bonneville 1976 Yamaha DT175 1974 Honda MT125 |
|
04-10-2024, 06:07 PM | #5 |
Join Date: May 2023
Posts: 17
|
Thanks, that makes sense. The other small nipple takes overflow fuel back to the intake. I suppose the second one could be connected to a hose that arcs up and then empties down below the engine. I assume both are there in case the float valve sticks open.
|
|
04-10-2024, 08:37 PM | #7 |
Join Date: Aug 2009
Posts: 572
|
Remove the hose end from the float bowl drain spigot, measure that hose length and make a second one the same length. Put it on the vent tube you circled by the choke lever. Run the left side up, over and down the opposite side, doing the same on the right side to the opposite side. Two small zip ties to keep them together (and out of the way) to allow the air pressure to equalize in the float bowl. The pic below shows those two hoses are kept together with a small plastic sleeve.
Don't forget to add a length of hose to the float bowl drain tube. |
|
04-10-2024, 09:50 PM | #8 |
Join Date: May 2023
Posts: 17
|
Dirtbkr188 -
Thanks for the picture. I have one more question. In my second photo above you can see a small nipple at the bottom of the float bowl. Is that used when draining the bowl, or does it have another purpose? |
|
04-22-2024, 07:35 AM | #9 |
Join Date: Apr 2024
Posts: 2
|
It sounds like you're delving into some serious tinkering with your engine! Regarding the mysterious nipple in the second picture, it might serve as an overflow or breather for the carburetor. Typically, it's left open to the atmosphere, but spectrum billing support it's wise to double-check your carburetor's manual or reach out to Zongshen for confirmation. Better safe than sorry when it comes to engine components! If you're uncertain, covering it temporarily while you gather more information could be a cautious approach.
|
|
|
|
|
|