Templar 250 resource guide - Page 5

Mumen Rider · Yesterday, 04:37 PM

Otom CRF250R front brake disc guards fit the front forks perfectly. You will need your own M6-1.0 bolts and washers to mount it.

Mumen Rider · Yesterday, 09:38 PM

I ran out of cut off wheels for my dremel tool but I have these pliers that managed to get the OEM carb screws out without much fuss even with the red thread lock on the bolts. Engineer PZ-57 Japanese pliers($16 on Amazon, a great alternative if you don't have a dremel tool or don't want to spend the money for this one job). You will need M4-.70x20mm screws to replace the OEM headless bolts.

I could only fit one .5mm shim under the needle and still have the white plastic needle retainer clip into the slide piston.

Yesterday, 04:37 PM	#61
Mumen Rider Join Date: May 2024 Location: Florida Posts: 26	Otom CRF250R front brake disc guards fit the front forks perfectly. You will need your own M6-1.0 bolts and washers to mount it.
	2

Yesterday, 09:38 PM	#62
Mumen Rider Join Date: May 2024 Location: Florida Posts: 26	I ran out of cut off wheels for my dremel tool but I have these pliers that managed to get the OEM carb screws out without much fuss even with the red thread lock on the bolts. Engineer PZ-57 Japanese pliers($16 on Amazon, a great alternative if you don't have a dremel tool or don't want to spend the money for this one job). You will need M4-.70x20mm screws to replace the OEM headless bolts. I could only fit one .5mm shim under the needle and still have the white plastic needle retainer clip into the slide piston.
	0