ChinaRiders Forums - View Single Post

TheBeege · 10-25-2014, 08:28 PM

Did some reading at http://www.dansmc.com/starter.htm. I couldn't quite tell if the carb uses an enriching circuit or a float plunger. It looks to me like an enriching circuit.

I full opened the throttle and did two kicks to clean it out, then I held the plunger all the way out and kicked without any throttle. Still no dice.

I tried holding the plunger for a few seconds, releasing it, opening the throttle by 1/4-ish, and kicking - no luck that way either.

Thoughts?

10-25-2014, 08:28 PM	#2
TheBeege Join Date: Sep 2014 Location: Santa Monica, CA Posts: 24	Did some reading at http://www.dansmc.com/starter.htm. I couldn't quite tell if the carb uses an enriching circuit or a float plunger. It looks to me like an enriching circuit. I full opened the throttle and did two kicks to clean it out, then I held the plunger all the way out and kicked without any throttle. Still no dice. I tried holding the plunger for a few seconds, releasing it, opening the throttle by 1/4-ish, and kicking - no luck that way either. Thoughts?
	0