[JerryHawk250]

Originally Posted by Emerikol

Jerry, where will you mount the centerstand? When I put the stand on my DR, it came with longer bolts and went in between the frame and the footpegs. It had one bolt that had a spacer on it to act as the picot stop, and the other bolt acted as the pivot. I'm going to Indianapolis first thing tomorrow morning for work, but I'll take a picture of The Mighty DR when I get back and post it. It might give you some geometry ideas for the stand you're planning to knock together.

I'm not sure how I am going to mount it. Lots of finger point engineering. I'll figure it out as I go. I have fabricated a few up in the past but each one was different. It will be bolt on so it can be taken off if need to. The last one I made was for a Yamaha Route 66 I had. It had two eyes already welded on the frame were I was able to pass a bolt through to mount it. Pm some pictures when ever you get a chance.