Quote:
Originally Posted by Ironmike
Ok didn't know it was that important. I'm gonna just cut the shaft. I don't use kicker anyway! Thx ARH for the explanation  |
You're welcome. Be sure you file any burrs after you cut it. You don't want to wait 3 months for a new seal to get here. Going this far, have you checked the rod bearing? It is a roller bearing, and can have a little movement back and forth, but none straight up and down. You don't have to put a lot of effort in lifting it. I used to just put a finger in the piston pin hole in the rod to check it for slop...ARH