Quote:
Originally Posted by Megadan
That squeak is likely from the pads being glazed. Take the pads off and lay some 400 to 800 grit sand paper flat on a table and very lightly rub the pad surface across it until the shine is gone. You arent looking to shave the pads down, just remove the gloss from the surface, which doesnt take much. Then clean the pads and rotor with the brake clean and give them a run in.
|
Thanks I'll give that a try.
Quote:
Originally Posted by Azhule
Have you done any carb adjustments yet (pilot screw, idle speed, jetting, etc.)?
Also check for restrictions in the exhaust header (welds on the inside and the engine to header gasket)... you should make it up those steep hills on these little engines... we do similar off road rides out here and we are starting our ride around 5,000 - 6,000 feet and end over 12,000... probably have 30% less power at these altitudes  |
No adjustments yet fully stock. This was the first time taking it out really, other then a few rides in the neighborhood. I have a new carb coming with the jet kits so ill be doing that tomorrow. Is there a video or guide on what you mean by the restrictions?