|
I installed 2 6 led side lights aimed with the highbeam today. It is wonderful. lights the gravel road up like it is in daytime. I will get the camera out tomorrow night. I mounted them off the lower fork clamps, in the side ways pattern. 2 leds up and down and 3 side to side. With the engine running at over 2k rpm the voltage is 14 volts on low beam and 13.6 on highbeam and I wished I had got a voltage check with the old 65 watt H4. I am running a led 1157 tail light. 76 watts total minus what ever I save with the 1157. Total lumins = 6500
I did block over an area at the bottom center of the headlight lens with paint to remove an objectionable pattern on the low beam and it did not effect the high beam. the pattern was at the top of each side of the low beam pattern. I will probably put silver tape over that area, I used white acrylic craft paint that should remove easily if I need too.
John
|